Re: [PATCH 3/6] tty: serial: 8250 core: add runtime pm

[Tony Lindgren]

* Sebastian Andrzej Siewior <bigeasy@xxxxxxxxxxxxx> [140709 10:52]:
> While comparing the OMAP-serial and the 8250 part of this I noticed that
> the the latter does not use runtime-pm. Here are the pieces. It is
> basically a get before first register access and a last_busy + put after
> last access.
> If I understand this correct, it should do nothing as long as
> pm_runtime_use_autosuspend() + pm_runtime_enable() isn't invoked on the
> device.
...

> --- a/drivers/tty/serial/8250/8250_core.c
> +++ b/drivers/tty/serial/8250/8250_core.c
> @@ -571,7 +573,17 @@ static void serial8250_set_sleep(struct uart_8250_port *p, int sleep)
>  			serial_out(p, UART_EFR, 0);
>  			serial_out(p, UART_LCR, 0);
>  		}
> +
> +		if (!device_may_wakeup(p->port.dev)) {
> +			if (sleep)
> +				pm_runtime_forbid(p->port.dev);
> +			else
> +				pm_runtime_allow(p->port.dev);
> +		}
>  	}
> +out:
> +	pm_runtime_mark_last_busy(p->port.dev);
> +	pm_runtime_put_autosuspend(p->port.dev);
>  }

The device_may_wakeup logic here is wrong as I described in the
earlier thread. For runtime PM, the wake-up events should be
always enabled. So the device_may_wakeup checks should be only
done for suspend and resume.

Regards,

Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/