Re: [PATCH 6/8 V2] staging: dgap: remove unneeded dgap_err()

From: DaeSeok Youn
Date: Tue Jul 15 2014 - 19:21:38 EST


Hi,

2014-07-16 0:29 GMT+09:00 Greg KH <gregkh@xxxxxxxxxxxxxxxxxxx>:
> On Tue, Jul 15, 2014 at 06:11:44PM +0900, Daeseok Youn wrote:
>> The dgap_err() is printing a message with pr_err(),
>> so all those are replaced.
>>
>> Use definition "pr_fmt" and then all of "dgap:" in
>> the beginning of print messages are removed.
>>
>> And also removed "out of memory" message because
>> the kernel has own message for that.
>>
>> Signed-off-by: Daeseok Youn <daeseok.youn@xxxxxxxxx>
>> ---
>> V2: use pr_fmt "dgap:" prefix on print message on dgap.
>> remove "out of memory" message.
>>
>> Adds Mark to TO list and CC list for checking send
>> this email properly to him.
>>
>> drivers/staging/dgap/dgap.c | 306 +++++++++++++++++++------------------------
>> 1 files changed, 133 insertions(+), 173 deletions(-)
>>
>> diff --git a/drivers/staging/dgap/dgap.c b/drivers/staging/dgap/dgap.c
>> index 06c55cb..9e750fb 100644
>> --- a/drivers/staging/dgap/dgap.c
>> +++ b/drivers/staging/dgap/dgap.c
>> @@ -41,6 +41,8 @@
>> */
>> #undef DIGI_CONCENTRATORS_SUPPORTED
>>
>> +#define pr_fmt(fmt) "dgap: " fmt
>> +
>> #include <linux/kernel.h>
>> #include <linux/module.h>
>> #include <linux/pci.h>
>> @@ -153,7 +155,6 @@ static void dgap_firmware_reset_port(struct channel_t *ch);
>> static int dgap_gettok(char **in);
>> static char *dgap_getword(char **in);
>> static int dgap_checknode(struct cnode *p);
>> -static void dgap_err(char *s);
>>
>> /*
>> * Function prototypes from dgap_sysfs.h
>> @@ -815,7 +816,7 @@ static struct board_t *dgap_found_board(struct pci_dev *pdev, int id,
>> if (ret)
>> goto free_brd;
>>
>> - pr_info("dgap: board %d: %s (rev %d), irq %ld\n",
>> + pr_info("board %d: %s (rev %d), irq %ld\n",
>> boardnum, brd->name, brd->rev, brd->irq);
>
> Almost all of the pr_*() calls in this driver should be converted over
> to use dev_*() calls instead. And some of them, like this one, should
> be removed entirely (no need for a driver to be "noisy" when a device
> for it is found, it should be quiet if at all possible, unless something
> went wrong.)
>
> So can you do that here instead? I've applied the earlier patches in
> this series, and stopped here.
OK. I can. pr_*() calls are replaced with dev_*() calls.
And also removes some of print message which are useless like "out
of memory"

Thanks.

regards,
Daeseok Youn
>
> thanks,
>
> greg k-h
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/