[PATCH v11 7/8] ARM: berlin: add the AHCI node for the BG2Q

[Antoine TÃnart]

The BG2Q has an AHCI SATA controller. Add the corresponding nodes
(AHCI, PHY) into its device tree.

Signed-off-by: Antoine TÃnart <antoine.tenart@xxxxxxxxxxxxxxxxxx>
---
 arch/arm/boot/dts/berlin2q.dtsi | 39 +++++++++++++++++++++++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/arch/arm/boot/dts/berlin2q.dtsi b/arch/arm/boot/dts/berlin2q.dtsi
index 635a16a64cb4..658975d22df7 100644
--- a/arch/arm/boot/dts/berlin2q.dtsi
+++ b/arch/arm/boot/dts/berlin2q.dtsi
@@ -303,6 +303,45 @@
 			clock-names = "refclk";
 		};
 
+		ahci: sata@e90000 {
+			compatible = "marvell,berlin2q-ahci", "generic-ahci";
+			reg = <0xe90000 0x1000>;
+			interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&chip CLKID_SATA>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			sata0: sata-port@0 {
+				reg = <0>;
+				phys = <&sata_phy 0>;
+				status = "disabled";
+			};
+
+			sata1: sata-port@1 {
+				reg = <1>;
+				phys = <&sata_phy 1>;
+				status = "disabled";
+			};
+		};
+
+		sata_phy: phy@e900a0 {
+			compatible = "marvell,berlin2q-sata-phy";
+			reg = <0xe900a0 0x200>;
+			clocks = <&chip CLKID_SATA>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			#phy-cells = <1>;
+			status = "disabled";
+
+			sata-phy@0 {
+				reg = <0>;
+			};
+
+			sata-phy@1 {
+				reg = <1>;
+			};
+		};
+
 		apb@fc0000 {
 			compatible = "simple-bus";
 			#address-cells = <1>;
-- 
1.9.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/