Re: [PATCH] ARM: at91: at91sam9x5: sets NPCS0 (PA14) back to GPIO

[Alexandre Belloni]

On 25/07/2014 at 10:37:31 +0200, JiÅÃ Prchal wrote :
> 
> 
> Dne 25.7.2014 v 10:30 Alexandre Belloni napsal(a):
> >Hi,
> >
> >On 25/07/2014 at 08:14:40 +0200, JiÅÃ Prchal wrote :
> >>I'm using custom board. My spi node:
> >>			spi0: spi@f0000000 {
> >
> >You should override the pinctrl here as you are using gpios for the cs.
> >				pinctrl-0 = <&pinctrl_spi0_custom>;
> >
> >>				status = "okay";
> >>				cs-gpios = <&pioA 23 0
> >>					    &pioA 22 0
> >>					    &pioC 29 0
> >>					    &pioA 14 0>;
> >>
> >
> >		pinctrl@fffff400 {
> >				spi0 {
> >					 pinctrl_spi0_custom: spi0-custom {
> >							 atmel,pins =
> >									 <AT91_PIOA 23 AT91_PERIPH_GPIO AT91_PINCTRL_NONE>,
> >									 <AT91_PIOA 22 AT91_PERIPH_GPIO AT91_PINCTRL_NONE>,
> >									 <AT91_PIOC 29 AT91_PERIPH_GPIO AT91_PINCTRL_NONE>,
> >									 <AT91_PIOA 14 AT91_PERIPH_GPIO AT91_PINCTRL_NONE>;
> >					 };
> >				};
> >		};
> >
> Of course, it's the way, but in all other drivers, for example LEDS,
> it's not needed. And in other way, if I will not use PA14 at all,
> the pin will goes down every spi transfer.

You must not assumed that the pins are muxed to their default state
which is gpio and you should set the pinctrl accordingly for each
device.

If you don't use PA14 at all, then you don't really care about its
state...


-- 
Alexandre Belloni, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/