From http://www.ti.com/lit/pdf/SWCZ010 :
Glitch on SDA-SCL not managed correctly by the I2C IP
Impact:
The standard specifies that the I2C transfer should restart on a start
event in all cases. The current design does not support two consecutive
Start conditions. This can cause the first real access after such a
glitch to be corrupted.
Description:
An unexpected glitch on SDA and SCL can generate a wrong start event.
In the current design, the SCL line must toggle two times to detect a
new start event and completely restart the I2C access; hence the real
start event is not detected in the case of a single SCL toggle.
Workaround:
Repeat I2C access.
The first access to the tps65910 that we do is when loading the regmap
in the probe function. If there has been a glitch during boot and the
erratum is triggered, then the regmap loading will fail with -REMOTEIO
since the I2C transfer is not ACKed by the tps65910.
A simple retry will work around it, because a subsequent I2C start
condition is detected properly by the tps65910.
Signed-off-by: Arnout Vandecappelle (Essensium/Mind) <arnout@xxxxxxx>
---
This patch is based on v3.17-rc1.
Build-tested with omap2plus_defconfig.
Runtime tested based on v3.4.97 with a custom config.
---
drivers/mfd/tps65910.c | 12 +++++++++++-
1 file changed, 11 insertions(+), 1 deletion(-)
diff --git a/drivers/mfd/tps65910.c b/drivers/mfd/tps65910.c
index f243e75..cc1ca33 100644
--- a/drivers/mfd/tps65910.c
+++ b/drivers/mfd/tps65910.c
@@ -487,8 +487,18 @@ static int tps65910_i2c_probe(struct i2c_client *i2c,
tps65910->id = chip_id;