Re: [PATCH 0/7] MIPS: Move device-tree files to a common location

[Jonas Gorski]

On Sat, Aug 23, 2014 at 12:10 AM, Andrew Bresticker
<abrestic@xxxxxxxxxxxx> wrote:
> On Fri, Aug 22, 2014 at 1:57 PM, David Daney <ddaney.cavm@xxxxxxxxx> wrote:
>> On 08/22/2014 01:42 PM, Florian Fainelli wrote:
>>>
>>> On Aug 21, 2014 3:05 PM, "Andrew Bresticker" <abrestic@xxxxxxxxxxxx
>>> <mailto:abrestic@xxxxxxxxxxxx>> wrote:
>>>  >
>>>  > To be consistent with other architectures and to avoid unnecessary
>>>  > makefile duplication, move all MIPS device-trees to arch/mips/boot/dts
>>>  > and build them with a common makefile.
>>>
>>> I recall reading that the ARM organization for DTS files was a bit
>>> unfortunate and should have been something like:
>>>
>>> arch/arm/boot/dts/<vendor>/
>>>
>>> Is this something we should do for the MIPS and update the other
>>> architectures to follow that scheme?
>>
>>
>> If we choose not to intermingle .dts files from all the vendors in a single
>> directory, why do anything at all?  Currently the .dts files for a vendor
>> are nicely segregated with the rest of the vendors code under a single
>> directory.
>>
>> Personally I think things are fine as they are.  Any common code remaining
>> in the Makefiles could be moved to the scripts directory for a smaller
>> change.
>
> Assuming we don't move them to a common location just to segregate
> them again, it makes MIPS consistent with every other architecture
> (not just ARM!) using DT.  It also makes it easier to introduce common
> changes later on, like the 'dtbs' or 'dtbs_install' make targets.

I think having dts files under a predictable location is a good idea,
especially if it allows common code/targets as "dtbs".

Maybe a totally insane idea, but how this for having the cake and eating it too:

arch/mips/boot/dts/*.dts => dts files to be built along side the kernel as .dtbs

arch/mips/<mach>/*.dts => dts files built into the kernel

(the ../*.dts isn't meant as they should be in the top directory, just
somewhere in that sub tree)

Because I can see a use case where you want both. For example octeon
uses generic device tree boards to use as a basis if the bootloader
did not provide one/is too old, but maybe also provide dts files for
known boards, which shouldn't be included in the kernel binary itself.

And I would like to do a similar thing when I want to convert bcm63xx
to device tree, i.e. have dts files for supported boards, but also
include a "standard"/"fall-back" dts for each of the supported SoCs to
load if there is no dtb passed and the old board registration code is
used.


Jonas
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/