Re: [PATCH v2 1/8] phy: miphy28lp: Add Device Tree bindings for the MiPHY28lp

[Gabriel Fernandez]

Hi Kishon,

ok will be fix to v3

BR

Gabriel

On 8 September 2014 16:33, Kishon Vijay Abraham I <kishon@xxxxxx> wrote:
> Hi,
>
> On Wednesday 03 September 2014 09:07 PM, Gabriel FERNANDEZ wrote:
>> The MiPHY28lp is a Generic PHY which can serve various SATA or PCIe
>> or USB3 devices.
>>
>> Signed-off-by: alexandre torgue <alexandre.torgue@xxxxxx>
>> Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@xxxxxx>
>> Signed-off-by: Gabriel Fernandez <gabriel.fernandez@xxxxxxxxxx>
>> ---
>>  .../devicetree/bindings/phy/phy-miphy28lp.txt      | 126 +++++++++++++++++++++
>>  1 file changed, 126 insertions(+)
>>  create mode 100644 Documentation/devicetree/bindings/phy/phy-miphy28lp.txt
>>
>> diff --git a/Documentation/devicetree/bindings/phy/phy-miphy28lp.txt b/Documentation/devicetree/bindings/phy/phy-miphy28lp.txt
>> new file mode 100644
>> index 0000000..5e307af
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/phy/phy-miphy28lp.txt
>> @@ -0,0 +1,126 @@
>> +STMicroelectronics STi MIPHY28LP PHY binding
>> +============================================
>> +
>> +This binding describes a miphy device that is used to control PHY hardware
>> +for SATA, PCIe or USB3.
>> +
>> +Required properties (controller (parent) node):
>> +- compatible : Should be "st,miphy28lp-phy"
>> +- st,syscfg  : Should be a phandle of the system configuration register group
>> +               which contain the SATA, PCIe or USB3 mode setting bits
>> +
>> +Required nodes       :  A sub-node is required for each channel the controller
>> +                provides. Address range information including the usual
>> +                'reg' and 'reg-names' properties are used inside these
>> +                nodes to describe the controller's topology. These nodes
>> +                are translated by the driver's .xlate() function.
>> +
>> +Required properties (port (child) node):
>> +- #phy-cells : Should be 1 (See second example)
>> +               Cell after port phandle is device type from:
>> +                     - MIPHY_TYPE_SATA
>> +                     - MIPHY_TYPE_PCI
>> +                     - MIPHY_TYPE_USB3
>> +- reg                : Address and length of the register set for the device
>> +- reg-names  : The names of the register addresses corresponding to the registers
>> +               filled in "reg". Is can also contain the offset of the system configuration
>
> %s/Is/It
>
> Thanks
> Kishon
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/