Re: [RFC PATCH] tty: serial: core: Only invoke ->start_tx() if there is data to send

[Peter Hurley]

On 09/10/2014 03:33 PM, Sebastian Andrzej Siewior wrote:
> I noticed that the serial8250_tx_dma() is invoked sometimes while
> uart_circ_empty() says that the buffer is empty.
> 
> I tracked one occuring down to:
> 
> n_tty_write()
> 	 => O_OPOST(tty))
> 	   => the while loop did something but neither tty's ->write()
> 	      nor its ->uart_put_char() callback was invoked().
> 	   => tty->ops->flush_chars() is invoked with an empty buffer.
> 
> For the 8250 uart driver we end up with:
> - DMA enabled
>   nothing, just return (except there is DMA_TX bug or runtime-PM then we
>   behave like in the no DMA case)
> 
> - no DMA
>   enable THRI interrupt, wait for it, disable THRI interrupt again
>   because there is nothing to be done.
> 
> While I don't know if it safe to drop that flush in n_tty if the buffer
> is empty, it should not do any harm in serial's core part to not invoke
> ->start_tx() if the buffer is empty.

The serial core can't assume that start_tx() does not need invoking
because hardware that can stop_tx() with data in the transmitter
won't restart if the ring buffer is empty but data is still in the
transmitter. [Note that the 16C950 port type does this in the 8250 driver.]

So this has to be handled in the 8250 driver.

What is the actual issue? Are you trying not to unnecessarily wake
the omap hardware if runtime-PM is on?

Regards,
Peter Hurley

> Signed-off-by: Sebastian Andrzej Siewior <bigeasy@xxxxxxxxxxxxx>
> ---
>  drivers/tty/serial/serial_core.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/tty/serial/serial_core.c b/drivers/tty/serial/serial_core.c
> index 5a78f6940760..e55724a911d5 100644
> --- a/drivers/tty/serial/serial_core.c
> +++ b/drivers/tty/serial/serial_core.c
> @@ -90,7 +90,8 @@ static void __uart_start(struct tty_struct *tty)
>  	struct uart_state *state = tty->driver_data;
>  	struct uart_port *port = state->uart_port;
>  
> -	if (!tty->stopped && !tty->hw_stopped)
> +	if (!tty->stopped && !tty->hw_stopped &&
> +			!uart_circ_empty(&port->state->xmit))
>  		port->ops->start_tx(port);
>  }
>  
> 

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/