Re: [PATCH v3 1/2] PCI: keystone: remove handle of PCI mode configuration

[Murali Karicheri]

On 09/10/2014 01:12 PM, Murali Karicheri wrote:
> Keystone PCI hardware supports both RC and EP modes and devcfg
> register has bits to boot strap the device to either of these modes.
> It seems proper to add this functionality to the boot loader rather
> than in the driver as device will be operating in either mode, not
> both any time. Currently the driver supports only RC mode and hence
> register configuration in the driver is not needed and driver can
> assume this is a RC hardware.
>
> Also update the DT documentation accordingly.
>
> Signed-off-by: Murali Karicheri<m-karicheri2@xxxxxx>
> Acked-by: Arnd Bergmann<arnd@xxxxxxxx>
> ---
> 	v3 - No change
> 	v2 - Added this separate patch to remove pci mode handling
>   .../devicetree/bindings/pci/pci-keystone.txt       |    4 +---
>   drivers/pci/host/pci-keystone.c                    |   21 ++------------------
>   2 files changed, 3 insertions(+), 22 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/pci/pci-keystone.txt b/Documentation/devicetree/bindings/pci/pci-keystone.txt
> index ceb3e24..bedacf0 100644
> --- a/Documentation/devicetree/bindings/pci/pci-keystone.txt
> +++ b/Documentation/devicetree/bindings/pci/pci-keystone.txt
> @@ -13,9 +13,7 @@ Required Properties:-
>
>   compatibility: "ti,keystone-pcie"
>   reg:	index 1 is the base address and length of DW application registers.
> -	index 2 is the base address and length of PCI mode configuration
> -	register.
> -	index 3 is the base address and length of PCI device ID register.
> +	index 2 is the base address and length of PCI device ID register.
>
>   pcie_msi_intc : Interrupt controller device node for MSI IRQ chip
>   	interrupt-cells: should be set to 1
> diff --git a/drivers/pci/host/pci-keystone.c b/drivers/pci/host/pci-keystone.c
> index ff8ed25..f1119eb 100644
> --- a/drivers/pci/host/pci-keystone.c
> +++ b/drivers/pci/host/pci-keystone.c
> @@ -35,10 +35,6 @@
>   #define MAX_MSI_HOST_IRQS		8
>   #define MAX_LEGACY_HOST_IRQS		4
>
> -/* RC mode settings masks */
> -#define PCIE_RC_MODE		BIT(2)
> -#define PCIE_MODE_MASK		(BIT(1) | BIT(2))
> -
>   /* DEV_STAT_CTRL */
>   #define PCIE_CAP_BASE		0x70
>
> @@ -355,7 +351,6 @@ static int __init ks_pcie_probe(struct platform_device *pdev)
>   	void __iomem *reg_p;
>   	struct phy *phy;
>   	int ret = 0;
> -	u32 val;
>
>   	ks_pcie = devm_kzalloc(&pdev->dev, sizeof(*ks_pcie),
>   				GFP_KERNEL);
> @@ -365,18 +360,6 @@ static int __init ks_pcie_probe(struct platform_device *pdev)
>   	}
>   	pp =&ks_pcie->pp;
>
> -	/* index 2 is the devcfg register for RC mode settings */
> -	res = platform_get_resource(pdev, IORESOURCE_MEM, 2);
> -	reg_p = devm_ioremap_resource(dev, res);
> -	if (IS_ERR(reg_p))
> -		return PTR_ERR(reg_p);
> -
> -	/* enable RC mode in devcfg */
> -	val = readl(reg_p);
> -	val&= ~PCIE_MODE_MASK;
> -	val |= PCIE_RC_MODE;
> -	writel(val, reg_p);
> -
>   	/* initialize SerDes Phy if present */
>   	phy = devm_phy_get(dev, "pcie-phy");
>   	if (!IS_ERR_OR_NULL(phy)) {
> @@ -385,8 +368,8 @@ static int __init ks_pcie_probe(struct platform_device *pdev)
>   			return ret;
>   	}
>
> -	/* index 3 is to read PCI DEVICE_ID */
> -	res = platform_get_resource(pdev, IORESOURCE_MEM, 3);
> +	/* index 2 is to read PCI DEVICE_ID */
> +	res = platform_get_resource(pdev, IORESOURCE_MEM, 2);
>   	reg_p = devm_ioremap_resource(dev, res);
>   	if (IS_ERR(reg_p))
>   		return PTR_ERR(reg_p);
Bjorn,

These patches need to go onto host-keystone as well for v3.18. If you 
you have any comments, please let me know so that I can address them. I 
have incorporated comments from Arnd already.

Thanks.

Murali
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/