Re: [PATCH v3 1/2] PCI: keystone: remove handle of PCI mode configuration

[Bjorn Helgaas]

On Wed, Sep 10, 2014 at 01:12:38PM -0400, Murali Karicheri wrote:
> Keystone PCI hardware supports both RC and EP modes and devcfg
> register has bits to boot strap the device to either of these modes.
> It seems proper to add this functionality to the boot loader rather
> than in the driver as device will be operating in either mode, not
> both any time. Currently the driver supports only RC mode and hence
> register configuration in the driver is not needed and driver can
> assume this is a RC hardware.
> 
> Also update the DT documentation accordingly.
> 
> Signed-off-by: Murali Karicheri <m-karicheri2@xxxxxx>
> Acked-by: Arnd Bergmann <arnd@xxxxxxxx>

Both applied to pci/host-keystone for v3.18, thanks!

> ---
> 	v3 - No change
> 	v2 - Added this separate patch to remove pci mode handling
>  .../devicetree/bindings/pci/pci-keystone.txt       |    4 +---
>  drivers/pci/host/pci-keystone.c                    |   21 ++------------------
>  2 files changed, 3 insertions(+), 22 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/pci/pci-keystone.txt b/Documentation/devicetree/bindings/pci/pci-keystone.txt
> index ceb3e24..bedacf0 100644
> --- a/Documentation/devicetree/bindings/pci/pci-keystone.txt
> +++ b/Documentation/devicetree/bindings/pci/pci-keystone.txt
> @@ -13,9 +13,7 @@ Required Properties:-
>  
>  compatibility: "ti,keystone-pcie"
>  reg:	index 1 is the base address and length of DW application registers.
> -	index 2 is the base address and length of PCI mode configuration
> -	register.
> -	index 3 is the base address and length of PCI device ID register.
> +	index 2 is the base address and length of PCI device ID register.
>  
>  pcie_msi_intc : Interrupt controller device node for MSI IRQ chip
>  	interrupt-cells: should be set to 1
> diff --git a/drivers/pci/host/pci-keystone.c b/drivers/pci/host/pci-keystone.c
> index ff8ed25..f1119eb 100644
> --- a/drivers/pci/host/pci-keystone.c
> +++ b/drivers/pci/host/pci-keystone.c
> @@ -35,10 +35,6 @@
>  #define MAX_MSI_HOST_IRQS		8
>  #define MAX_LEGACY_HOST_IRQS		4
>  
> -/* RC mode settings masks */
> -#define PCIE_RC_MODE		BIT(2)
> -#define PCIE_MODE_MASK		(BIT(1) | BIT(2))
> -
>  /* DEV_STAT_CTRL */
>  #define PCIE_CAP_BASE		0x70
>  
> @@ -355,7 +351,6 @@ static int __init ks_pcie_probe(struct platform_device *pdev)
>  	void __iomem *reg_p;
>  	struct phy *phy;
>  	int ret = 0;
> -	u32 val;
>  
>  	ks_pcie = devm_kzalloc(&pdev->dev, sizeof(*ks_pcie),
>  				GFP_KERNEL);
> @@ -365,18 +360,6 @@ static int __init ks_pcie_probe(struct platform_device *pdev)
>  	}
>  	pp = &ks_pcie->pp;
>  
> -	/* index 2 is the devcfg register for RC mode settings */
> -	res = platform_get_resource(pdev, IORESOURCE_MEM, 2);
> -	reg_p = devm_ioremap_resource(dev, res);
> -	if (IS_ERR(reg_p))
> -		return PTR_ERR(reg_p);
> -
> -	/* enable RC mode in devcfg */
> -	val = readl(reg_p);
> -	val &= ~PCIE_MODE_MASK;
> -	val |= PCIE_RC_MODE;
> -	writel(val, reg_p);
> -
>  	/* initialize SerDes Phy if present */
>  	phy = devm_phy_get(dev, "pcie-phy");
>  	if (!IS_ERR_OR_NULL(phy)) {
> @@ -385,8 +368,8 @@ static int __init ks_pcie_probe(struct platform_device *pdev)
>  			return ret;
>  	}
>  
> -	/* index 3 is to read PCI DEVICE_ID */
> -	res = platform_get_resource(pdev, IORESOURCE_MEM, 3);
> +	/* index 2 is to read PCI DEVICE_ID */
> +	res = platform_get_resource(pdev, IORESOURCE_MEM, 2);
>  	reg_p = devm_ioremap_resource(dev, res);
>  	if (IS_ERR(reg_p))
>  		return PTR_ERR(reg_p);
> -- 
> 1.7.9.5
> 
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/