Re: [tip:x86/platform] x86/intel/quark: Switch off CR4.PGE so TLB flush uses CR3 instead

From: Bryan O'Donoghue
Date: Wed Sep 24 2014 - 11:58:23 EST




I believe there is one more change needed: there is a __flush_tlb_all()
in the early code which gets executed before the above code runs; the
easiest fix is to just add a __flush_tlb() immediately after it.

This should have been pushed upstream, and not stayed in the BSP kernel.

Peter.

You're talking about void __init setup_arch() right ?

The code looks like this

load_cr3(swapper_pg_dir);
__flush_tlb_all();

Note that on Quark the method to invalidate the TLB is by reloading CR3 - which is immediately prior to __flush_tlb_all();

So __flush_tlb_all(); will do nothing but that's OK since load_cr3() already flushed the TLB - including any PTE with PGE set


Best,
Bryan
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/