Re: [PATCH to be tested] serial: msm_serial: add missing sysrq handling

[Stephen Boyd]

Hi Frank,

On 08/13/14 19:42, Frank Rowand wrote:
> On 8/13/2014 7:33 PM, Frank Rowand wrote:
>> On 8/12/2014 5:23 PM, Stephen Boyd wrote:
>>> On 08/06/14 17:16, Frank Rowand wrote:
> < snip >
>  
>> The patches you sent are a little hard to read since they modify further code
>> that my patch modified.  So I have redone your patches, as if my patch was
>> not previously applied.  Hopefully I did not make any mistakes there.  I will
>> reply to this email with each of your redone patches.
> Stephen's patch alternative number 2:

I had a discussion with the hardware engineer. Apparently the break bit
in the SR register is not "sticky" so it doesn't always stay set when
the handle_rx_dm() function runs and a break has entered the fifo. I
used your debug patches to confirm this (I never see the break status
bit when the fifo has multiple characters in it). It sounds like this
bit can't really be used reliably. The recommendation is to use either
the break start or break stop interrupt to detect when a break has
occurred and then search the fifo for the break character (an all zero
character). If there are two such characters then we can't be certain
when the break was, but the chances of this seem really slim considering
that the stale timeout probably triggers first before a human can type a
character after the break.

On 1.4 hardware we can change the mode to be single character and then
we can reliably detect the break character because only one character
enters the fifo and the higher bits of the fifo can be used to detect if
it is a break or not. Making that change is probably not that hard, I
believe we can reuse all the handle_rx_dm logic and force single
character mode on consoles, but 1.3 hardware doesn't benefit from this
change. I'll try to get something together soon that tries to make this
all work as best as it can.

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/