Re: [PATCH] bcma: Add dependency on OF_ADDRESS

[Guenter Roeck]

On Thu, Oct 09, 2014 at 11:48:08PM +0200, Hauke Mehrtens wrote:
> On 10/09/2014 09:25 PM, Guenter Roeck wrote:
> > On Thu, Oct 09, 2014 at 08:28:31PM +0200, Hauke Mehrtens wrote:
> >> On 10/09/2014 07:29 PM, Guenter Roeck wrote:
> >>> On Thu, Oct 09, 2014 at 07:18:31PM +0200, Arend van Spriel wrote:
> >>>> On 10/09/14 19:15, Arend van Spriel wrote:
> >>>>> On 10/09/14 18:54, RafaÅ MiÅecki wrote:
> >>>>>> On 9 October 2014 18:41, Guenter Roeck<linux@xxxxxxxxxxxx> wrote:
> >>>>>>> Commit 2101e533f41a ("bcma: register bcma as device tree driver")
> >>>>>>> introduces a hard dependency on OF_ADDRESS into the bcma driver.
> >>>>>>> OF_ADDRESS is specifically disabled for the sparc architecture.
> >>>>>>> This results in the following error when building sparc64:allmodconfig.
> >>>>>
> >>>>> Does this mean on sparc (using allmodconfig) you will get CONFIG_OF and
> >>>>> !CONFIG_OF_ADDRESS? Does that makes sense?
> >>>>
> >>>> Is CONFIG_OF is used on sparc to access OpenBoot information?
> >>>>
> >>> I have no idea. All I know is that the driver doesn't build anymore with OF
> >>> enabled and OF_ADDRESS disabled.
> >>
> >> Device tree support in bcma is only needed on some SoC, when this is
> >> used on a PCIe card it is not needed.
> >>
> >> I would just deactivate the parts that are using device tree in bcma
> >> when it is not available. I will send a patch after having something to eat.
> >>
> > Devicetree dependency is already covered with #ifdef CONFIG_OF. Problem is
> > that it really needs #ifdef CONFIG_OF_ADDRESS. Though even that might be
> > better than my patch, since it would at least build the driver on sparc
> > as it used to do.
> > 
> >> Is there a better method which is compatible with SPARC than using
> >> of_translate_address() to get the reg address and also take the ranges
> >> attribute of the bus into account?
> >>
> > No idea, sorry. Can you by any chance use pcie device information
> > instead of depending on devicetree data ?
> 
> Device tree is not used for PCIe devices in bcma. We only use it when
> bcma is used for the system bus on some Broadcom SoCs, currently there
> is no plan to use device tree for PCIe devices in bcma. I think bcma is
> only used on wifi cards connected via PCIe on Sparc systems.
> 
Ok. Well, with your patch the code is as good or as bad as it was prior to
adding devicetree support to the driver, so hopefully should work.

Guenter
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/