Re: [PATCH] mmc: dw_mmc: Reset DMA before enabling IDMAC

[Alim Akhtar]

Hi Eddie,

On Thu, Oct 9, 2014 at 7:43 PM, Eddie Cai(èæ) <eddie.cai@xxxxxxxxxxxxxx> wrote:
> Hi Alim
>
> 2014å10æ8æ äå4:28ä "Alim Akhtar" <alim.akhtar@xxxxxxxxx>åéï
>
>
>>
>> Hi Sonny/Doug,
>>
>> On Mon, Oct 6, 2014 at 11:23 PM, Sonny Rao <sonnyrao@xxxxxxxxxxxx> wrote:
>> > We've already got a reset of DMA after it's done.  Add one before we
>> > start DMA too.  This fixes a data corruption on Rockchip SoCs which
>> > will get bad data when doing a DMA transfer after doing a PIO transfer.
>> >
>> > We tested this on an Exynos 5800 with HS200 and didn't notice any
>> > difference in sequential read throughput.
>> >
>> > Signed-off-by: Sonny Rao <sonnyrao@xxxxxxxxxxxx>
>> > Signed-off-by: Doug Anderson <dianders@xxxxxxxxxxxx>
>> > ---
>> >  drivers/mmc/host/dw_mmc.c | 4 ++++
>> >  1 file changed, 4 insertions(+)
>> >
>> > diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
>> > index 69f0cc6..2b5401e 100644
>> > --- a/drivers/mmc/host/dw_mmc.c
>> > +++ b/drivers/mmc/host/dw_mmc.c
>> > @@ -83,6 +83,7 @@ struct idmac_desc {
>> >  #endif /* CONFIG_MMC_DW_IDMAC */
>> >
>> >  static bool dw_mci_reset(struct dw_mci *host);
>> > +static bool dw_mci_ctrl_reset(struct dw_mci *host, u32 reset);
>> >
>> >  #if defined(CONFIG_DEBUG_FS)
>> >  static int dw_mci_req_show(struct seq_file *s, void *v)
>> > @@ -448,6 +449,9 @@ static void dw_mci_idmac_start_dma(struct dw_mci
>> > *host, unsigned int sg_len)
>> >
>> >         dw_mci_translate_sglist(host, host->data, sg_len);
>> >
>> > +       /* Make sure to reset DMA in case we did PIO before this */
>> > +       dw_mci_ctrl_reset(host, SDMMC_CTRL_DMA_RESET);
>> > +
>> Though this is good to do, but this does not look complete to me.
>> dw_mmc data book does mention that " It is recommended that the host
>> issue reset to DMA interface by setting DMA_RESET bit of the CTRL
>> register and then issue a IDMAC software reset."
>> The above lines are from 'Transmission and reception with internal
>> DMA' section of the data book.
>> My suggestion here to add dw_mci_idmac_reset() call after this above
>> change.
>>
>> What is the controller version used in your case?
>
> it just compatible with dw mmc controler but not the same one. it is
> designed by rockchip.
>
Thats fine, I think every vendor (most of them) has a custom
implementation of dw_mmc, but they do have VERID register to check the
dw_mmc version.
The reason why I asked is, I have seen inconsistency in card
enumeration on few controller version, and this patch alone does not
help, and adding a call to dw_mci_idmac_reset() after DMA reset is
needed. And this is what is recommended in the synopsys's data book
also.
Do you see any issue/side effect after adding dw_mci_idmac_reset()?

>> >         /* Select IDMAC interface */
>> >         temp = mci_readl(host, CTRL);
>> >         temp |= SDMMC_CTRL_USE_IDMAC;
>> > --
>> > 1.8.3.2
>> >
>> > --
>> > To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
>> > the body of a message to majordomo@xxxxxxxxxxxxxxx
>> > More majordomo info at  http://vger.kernel.org/majordomo-info.html
>>
>>
>>
>> --
>> Regards,
>> Alim
>>
>>



-- 
Regards,
Alim
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/