Re: [PATCH v2 00/11] ARM: dts: zynq: Prepare Parallella

[Olof Johansson]

On Tue, Oct 21, 2014 at 1:52 PM, Andreas FÃrber <afaerber@xxxxxxx> wrote:
> Hi Olof and SÃren,
>
> Am 18.10.2014 um 06:28 schrieb Olof Johansson:
>> On Thu, Jul 24, 2014 at 4:00 PM, Andreas FÃrber <afaerber@xxxxxxx> wrote:
>>> Hello,
>>>
>>> This patch series adds an initial device tree for the Parallella board.
>>> UART, SD card, Ethernet are enabled.
>>> Not yet enabled are HDMI, QSPI flash and 2x USB.
>>
>> Andreas (Olofsson) kindly sent me a board, and I added it to the boot
>> farm today, it'll be included in boot reports from here on.
>
> Good to hear.
>
>> I did a test run with yesterday's -next It looks like networking isn't
>> working there at the moment, clock related. Same happens with 3.17 and
>> latest mainline, config multi_v7_defconfig:
>>
>> [WARN] [    7.943648] macb e000b000.ethernet eth0: unable to generate
>> target frequency: 125000000 Hz
>> [WARN] [   10.948681] macb e000b000.ethernet eth0: unable to generate
>> target frequency: 125000000 Hz
>
> I am unable to reproduce this in my setup - at Linus' tip
> c2661b806092d8ea2dccb7b02b65776555e0ee47 (v3.18-rc1-68-gc2661b8), make
> oldconfig'ing my /proc/config.gz.
>
> SÃren, in light of your explanations, should I be expecting problems
> with 1GbE or with 100MbE? My board is connected to a 1GbE switch.

My board might have old firmware/bitstream on it? It reports as:

U-Boot 2012.10-00003-g792c31c (Jan 03 2014 - 12:24:08)


-Olof
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/