Re: [PATCH 1/3] mfd: stmpe: add pull up/down register offsets for STMPE

[Dmitry Torokhov]

On Mon, Oct 20, 2014 at 07:46:05AM +0100, Lee Jones wrote:
> On Sat, 18 Oct 2014, Linus Walleij wrote:
> 
> > This adds the register offsets for pull up/down for the STMPE
> > 1601, 1801 and 24xx expanders. This is used to bias GPIO lines
> > and keypad lines.
> > 
> > Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
> > ---
> > Hi Sam, Lee: I think you should just ACK this so Dmitry can take the
> > patch series through the input tree, where the registers need to be
> > used to enable the keypad on the STMPE2401.
> > ---
> >  drivers/mfd/stmpe.c       | 4 ++++
> >  drivers/mfd/stmpe.h       | 3 +++
> >  include/linux/mfd/stmpe.h | 2 ++
> >  3 files changed, 9 insertions(+)
> 
> Does this need to go in with the other patches in the set?
> 
> I'm _guessing_ that, as you've sent them separately, they can be
> applied separately?
> 
> This needs to go in via MFD, but for my own reference:
> 
> Acked-by: Lee Jones <lee.jones@xxxxxxxxxx>

The new register definitions are needed for patch #3.  If you insist on
this going through MFD then please take the other 2 patches with my Ack
through MFD tree as well I do not think we need the whole song and dance
trying to synchronize 2 trees.

Thanks.

-- 
Dmitry
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/