Hi,
On Thu, Oct 23, 2014 at 02:38:38PM +0200, Mike Looijmans wrote:
Both the LTC2941 and LTC2943 measure battery capacity.
The LTC2943 is compatible with the LTC2941, it adds voltage and
temperature monitoring, and uses a slightly different conversion
formula for the charge counter.
To avoid confusion with e.g. the LTC2945, the driver is called
LTC2941 instead of LTC294X.
v2: Fix units of measurement: uV, uA and centidegrees.
v3: Correctly set configuration register. Allow negative values
for the sense resistor.
v4: Run checkpatch.pl and fix all errors and warnings.
Signed-off-by: Mike Looijmans <mike.looijmans@xxxxxxxx>
---
[...]
+ np = of_node_get(client->dev.of_node);
+
+ /* r_sense can be negative, when sense+ is connected to the battery
+ * instead of the sense-. This results in reversed measurements. */
+ ret = of_property_read_u32(np, "resistor-sense", &r_sense);
+ if (ret < 0) {
+ dev_err(&client->dev,
+ "Could not find resistor-sense in devicetree\n");
+ goto fail_name;
+ }
+ info->r_sense = r_sense;
+
+ ret = of_property_read_u32(np, "prescaler-exponent", &prescaler_exp);
+ if (ret < 0) {
+ dev_err(&client->dev,
+ "PrescalerExponent not in devicetree, assume max\n");
+ prescaler_exp = LTC2941_MAX_PRESCALER_EXP;
+ }
The device tree properties are not documented. Please document them
in a separate patch and Cc devicetree binding maintainers.
Apart from that the properties should be vendor prefixed (e.g.
"lltc,resistor-sense").