Re: [PATCH v2] [RESEND] mmc: add Toshiba PCI SD controller driver

[Ondrej Zary]

On Tuesday 04 November 2014 22:41:44 Ondrej Zary wrote:
> On Tuesday 04 November 2014 12:09:44 Ulf Hansson wrote:
> > On 2 November 2014 22:51, Ondrej Zary <linux@xxxxxxxxxxxxxxxxxxxx> wrote:
> > > This patch resurrects an old never-finished driver for Toshiba PCI SD
> > > controllers found in some older Toshiba laptops (such as Portege R100):
> > >
> > > 02:0d.0 System peripheral [0880]: Toshiba America Info Systems SD TypA Controller [1179:0805] (rev 05)
> > >
> > > The code is fixed, cleaned up and successfully tested with SD, SDHC, SDXC and
> > > MMC cards on Portege R100. (MMC cards don't even work in Windows!)
> > > SDIO probably does not work (don't have any SDIO card).
> > >
> > > The hardware is slow (around 2 MB/s - same in Windows) because it does not
> > > support bus mastering (busmaster enable bit cannot be set in PCI control reg).
> > > Also the card clock is limited to 16MHz (33MHz PCI clock divided by 2).
> > >
> > > Signed-off-by: Ondrej Zary <linux@xxxxxxxxxxxxxxxxxxxx>
> > 
> > Hi Ondrej,
> > 
> > Sorry for a very very late reply.
> > 
> 
> ...
> 
> > > +static void toshsd_init(struct toshsd_host *host);
> > > +static void toshsd_set_ios_unlocked(struct mmc_host *mmc, struct mmc_ios *ios);
> > 
> > I would implement these functions at the proper place instead of
> > having them defined here.
> > 
> > Moreover I think toshsd_set_ios_unlocked() could be renamed to
> > "__toshsd_set_ios()".
> 
> OK, will do.
>  
> > > +
> > > +static inline u16 toshsd_readw(struct toshsd_host *host, u16 reg)
> > > +{
> > > +       return ioread16(host->ioaddr + reg);
> > > +}
> > > +
> > > +static inline u32 toshsd_readl(struct toshsd_host *host, u16 reg)
> > > +{
> > > +       return ioread32(host->ioaddr + reg);
> > > +}
> > > +
> > > +static inline void toshsd_writew(struct toshsd_host *host, u16 reg, u16 val)
> > > +{
> > > +       iowrite16(val, host->ioaddr + reg);
> > > +}
> > > +
> > > +static inline void toshsd_writel(struct toshsd_host *host, u16 reg, u32 val)
> > > +{
> > > +       iowrite32(val, host->ioaddr + reg);
> > > +}
> > > +
> > > +static inline void toshsd_readl_rep(struct toshsd_host *host, u16 reg,
> > > +                                   void *dst, unsigned long count)
> > > +{
> > > +       ioread32_rep(host->ioaddr + reg, dst, count);
> > > +}
> > > +
> > > +static inline void toshsd_writel_rep(struct toshsd_host *host, u16 reg,
> > > +                                    const void *src, unsigned long count)
> > > +{
> > > +       iowrite32_rep(host->ioaddr + reg, src, count);
> > > +}
> > 
> > To me, all these wrapper functions seems a bit ugly. How about
> > invoking io* functions directly instead?
> 
> It's a matter of preference, some drivers use wrappers, some don't.
> I can remove them if they're not recommended in mmc subsystem.
>  
> ...
> 
> > > +               tasklet_schedule(&host->data_read_tasklet);
> > 
> > Instead of using a tasklet, I would advise to use a threaded IRQ.
>  
> Haven't used threaded IRQ yet, will try.
> 
> ...
> 
> > > +#ifdef CONFIG_PM
> > 
> > This should be CONFIG_PM_SLEEP.
> > 
> > > +
> > > +static int toshsd_suspend(struct pci_dev *pdev, pm_message_t state)
> > 
> > This is the legacy version of system PM callbacks. You need to convert
> > to the modern ones instead.
> > 
> > > +{
> > > +       struct toshsd_host *host = pci_get_drvdata(pdev);
> > > +
> > > +       toshsd_powerdown(host);
> > > +
> > > +       pci_save_state(pdev);
> > > +       pci_enable_wake(pdev, pci_choose_state(pdev, state), 0);
> > > +       pci_disable_device(pdev);
> > > +       pci_set_power_state(pdev, pci_choose_state(pdev, state));
> > > +
> > > +       return 0;
> > > +}
> > > +
> > > +static int toshsd_resume(struct pci_dev *pdev)
> > 
> > This is the legacy version of system PM callbacks. You need to convert
> > to the modern ones instead.
> 
> I just converted them and found that suspend does not work on current kernels
> when a SD card is inserted (even with unmodified toshsd driver):
> [  188.960862] dpm_run_callback(): mmc_bus_suspend+0x0/0x2c [mmc_core] returns -110
> [  188.960867] PM: Device mmc0:b368 failed to suspend: error -110
> [  188.960869] PM: Some devices failed to suspend, or early wake event detected
> 
> Is it a kernel bug or the driver is missing something?
> 

The same kernel with sdhci-pci works fine (on another HW) so the problem is
limited only to toshsd...
Seems that the MMC core is trying to do something with the card and it fails
with timeout:
[  885.750001] PM: Entering mem sleep
[  885.750023] Suspending console(s) (use no_console_suspend to debug)
[  885.750281] Command opcode: 7
[  885.750432] timeout!!!!!
[  885.750453] Command opcode: 7
[  885.750597] timeout!!!!!
[  885.750615] Command opcode: 7
[  885.750758] timeout!!!!!
[  885.750776] Command opcode: 7
[  885.750920] timeout!!!!!
[  885.750956] dpm_run_callback(): mmc_bus_suspend+0x0/0x2c [mmc_core] returns -110
[  885.750961] PM: Device mmc0:0007 failed to suspend: error -110

-- 
Ondrej Zary
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/