Re: [PATCH v2 5/5] i2c: davinci: use ICPFUNC to toggle I2C as gpio for bus recovery

[Grygorii Strashko]

On 11/26/2014 06:04 PM, Uwe Kleine-König wrote:
> On Wed, Nov 26, 2014 at 03:59:53PM +0200, Grygorii Strashko wrote:
>> Having a board where the I2C bus locks up occasionally made it clear
>> that the bus recovery in the i2c-davinci driver will only work on
>> some boards, because on regular boards, this will only toggle GPIO
>> lines that aren't muxed to the actual pins.
>>
>> The I2C controller on SoCs like da850 (and da830), Keystone 2 has the
>> built-in capability to bit-bang its lines by using the ICPFUNC registers
>> of the i2c controller.
>> Implement the suggested procedure by toggling SCL and checking SDA using
>> the ICPFUNC registers of the I2C controller when present. Allow platforms
>> to indicate the presence of the ICPFUNC registers with a has_pfunc platform
>> data flag and add optional DT property "ti,has-pfunc" to indicate
>> the same in DT.
> On what does it depend if this pfunc stuff works or not? Only the SoC,
> or also on some board specific properties?

SoC / set of SoCs. Also, similar feature is supported by OMAP and AM335x/AM437x SoCs
using I2C_SYSTEST register.

> Given the former using the
> compatible string to detect its availability would be better. (In this
> case also sorry, didn't consider this case when requesting the property
> in the last round.)
> 
> The patch looks ok.

regards,
-grygorii
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/