Re: [PATCH] ioc3: fix incorrect use of htons/ntohs

[Ben Hutchings]

On Sun, 2014-11-30 at 11:40 +0100, Lino Sanfilippo wrote:
> The protocol type in the ip header struct is a single byte variable. So there
> is no need to swap bytes depending on host endianness.
> 
> Signed-off-by: Lino Sanfilippo <LinoSanfilippo@xxxxxx>
> ---
> 
> Please note that I could not test this, since I dont have access to the
> concerning hardware.
> 
>  drivers/net/ethernet/sgi/ioc3-eth.c | 5 ++---
>  1 file changed, 2 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/net/ethernet/sgi/ioc3-eth.c b/drivers/net/ethernet/sgi/ioc3-eth.c
> index 7a254da..0bb303d 100644
> --- a/drivers/net/ethernet/sgi/ioc3-eth.c
> +++ b/drivers/net/ethernet/sgi/ioc3-eth.c
> @@ -540,8 +540,7 @@ static void ioc3_tcpudp_checksum(struct sk_buff *skb, uint32_t hwsum, int len)
>  
>  	/* Same as tx - compute csum of pseudo header  */
>  	csum = hwsum +
> -	       (ih->tot_len - (ih->ihl << 2)) +
> -	       htons((uint16_t)ih->protocol) +
> +	       (ih->tot_len - (ih->ihl << 2)) + ih->protocol +
>  	       (ih->saddr >> 16) + (ih->saddr & 0xffff) +
>  	       (ih->daddr >> 16) + (ih->daddr & 0xffff);
>

The pseudo-header is specified as:

                     +--------+--------+--------+--------+
                     |           Source Address          |
                     +--------+--------+--------+--------+
                     |         Destination Address       |
                     +--------+--------+--------+--------+
                     |  zero  |  PTCL  |    TCP Length   |
                     +--------+--------+--------+--------+

The current code zero-extends the protocol number to produce the 5th
16-bit word of the pseudo-header, then uses htons() to put it in
big-endian order, consistent with the other fields.  (Yes, it's doing
addition on big-endian words; this works even on little-endian machines
due to the way the checksum is specified.)

The driver should not be doing this at all, though.  It should set
skb->csum = hwsum; skb->ip_summed = CHECKSUM_COMPLETE; and let the
network stack adjust the hardware checksum.

> @@ -1417,7 +1416,7 @@ static int ioc3_start_xmit(struct sk_buff *skb, struct net_device *dev)
>  	 */
>  	if (skb->ip_summed == CHECKSUM_PARTIAL) {
>  		const struct iphdr *ih = ip_hdr(skb);
> -		const int proto = ntohs(ih->protocol);
> +		const int proto = ih->protocol;
>  		unsigned int csoff;
>  		uint32_t csum, ehsum;
>  		uint16_t *eh;

This should logically be __be16 proto = htons(ih->protocol), but the
current version should work in practice.

However, the driver should really use skb->csum_start and
skb->csum_offset to work out where the checksum belongs and which bytes
to cancel out.

Ben.

-- 
Ben Hutchings
The first rule of tautology club is the first rule of tautology club.

Attachment: signature.asc
Description: This is a digitally signed message part