[PATCH v3 2/2] dma: pl330: add DMA_PAUSE feature

[Robert Baldyga]

DMA_PAUSE command is used for halting DMA transfer on chosen channel.
It can be useful when we want to safely read residue before terminating
all requests on channel. Otherwise there can be situation when some data
is transferred before channel termination but after reading residue,
which obviously results with data loss. To avoid this situation we can
pause channel, read residue and then terminate all requests.
This scenario is common, for example, in serial port drivers.

Signed-off-by: Robert Baldyga <r.baldyga@xxxxxxxxxxx>
---
 drivers/dma/pl330.c | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/drivers/dma/pl330.c b/drivers/dma/pl330.c
index 2f4d561..ead4369 100644
--- a/drivers/dma/pl330.c
+++ b/drivers/dma/pl330.c
@@ -2137,6 +2137,25 @@ static int pl330_control(struct dma_chan *chan, enum dma_ctrl_cmd cmd, unsigned
 		pm_runtime_mark_last_busy(pl330->ddma.dev);
 		pm_runtime_put_autosuspend(pl330->ddma.dev);
 		break;
+	case DMA_PAUSE:
+		/*
+		 * We don't support DMA_RESUME command because of hardware
+		 * limitations, so after pausing the channel we cannot restore
+		 * it to active state. We have to terminate channel and setup
+		 * DMA transfer again. This pause feature was implemented to
+		 * allow safely read residue before channel termination.
+		 */
+		pm_runtime_get_sync(pl330->ddma.dev);
+		spin_lock_irqsave(&pch->lock, flags);
+
+		spin_lock(&pl330->lock);
+		_stop(pch->thread);
+		spin_unlock(&pl330->lock);
+
+		spin_unlock_irqrestore(&pch->lock, flags);
+		pm_runtime_mark_last_busy(pl330->ddma.dev);
+		pm_runtime_put_autosuspend(pl330->ddma.dev);
+		break;
 	case DMA_SLAVE_CONFIG:
 		slave_config = (struct dma_slave_config *)arg;
 
-- 
1.9.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/