Re: [PATCH] pinctrl: cherryview: Configure HiZ pins to be input when requested as GPIOs

[Linus Walleij]

On Thu, Jan 29, 2015 at 11:44 AM, Mika Westerberg
<mika.westerberg@xxxxxxxxxxxxxxx> wrote:

> If the pin is in HiZ mode when it is requested as GPIO its value cannot be
> read (it always returns 0). In order to cope with the Linux GPIO subsystem
> where we do not have such state at all, turn the pin to be input instead.
>
> Reported-by: Jerome Blin <jerome.blin@xxxxxxxxx>
> Signed-off-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>

Patch applied.

Since putting a pin into GPIO mode start poking around in essentially pin
control registers, we may need to revisit the issue of the pin control subsystem
not denying simultaneous use of a pin for a device muxing and GPIO.
Maybe the "strict" setting forcing a pin to be either one or the other on
a per-driver basis would enforce a better policy on this driver (and some
others).

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/