Re: [PATCH V2 RESEND] clk: mxs: Fix invalid 32-bit access to frac registers

[Fabio Estevam]

Hi Stefan,

On Thu, Feb 12, 2015 at 4:59 PM, Stefan Wahren <stefan.wahren@xxxxxxxx> wrote:
> Hi Fabio,
>
>> Fabio Estevam <festevam@xxxxxxxxx> hat am 11. Februar 2015 um 22:10
>> geschrieben:
>>
>>
>> On Wed, Feb 11, 2015 at 6:31 PM, Stefan Wahren <stefan.wahren@xxxxxxxx> wrote:
>>
>> >> I always get 0x5e5b5513 with or without your patch.
>> >
>> > very strange. Do you have any idea why IO1_STABLE is permanent low?
>>
>> On my case it is always 1.
>
> i expected the same behavior on my hardware.
>
> Do you use u-boot as bootloader?

Yes, I do.

>>
>> > Can you confirm the behavior according to your flash issue?
>>
>> In my tests IO1_STABLE stays the same.
>
> This wasn't the intension of my second question. I wanted to know about the
> state of the SPI NOR flash detection process.
>
> Does it sucessed if you apply the patch, but revert the changes in
> clk_ref_set_rate() from clk-ref.c?

I don't have my mx28evk setup available at the moment, but when I
applied your patch and reverted all the changes in clk-ref.c, then the
SPI flash detection works.

I haven't tested to only reverting the changes inside
clk_ref_set_rate(), but I can do it tomorrow.

Regards,

Fabio Estevam
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/