Re: [PATCH v4 2/3] leds: ktd2692: add device tree bindings for ktd2692

[Ingi Kim]

Hi Varka,

Thanks for the review

On 2015ë 03ì 25ì 12:31, Varka Bhadram wrote:
> On 03/25/2015 07:00 AM, Ingi Kim wrote:
>> This patch adds the device tree bindings for ktd2692 flash LEDs.
>> Add optional properties 'flash-timeout-us' to control flash timeout
>> and 'vin-supply' for flash-led regulator
>>
>> Signed-off-by: Ingi Kim <ingi2.kim@xxxxxxxxxxx>
>> ---
>>   .../devicetree/bindings/leds/leds-ktd2692.txt      | 33 ++++++++++++++++++++++
>>   1 file changed, 33 insertions(+)
>>   create mode 100644 Documentation/devicetree/bindings/leds/leds-ktd2692.txt
>>
>> diff --git a/Documentation/devicetree/bindings/leds/leds-ktd2692.txt b/Documentation/devicetree/bindings/leds/leds-ktd2692.txt
>> new file mode 100644
>> index 0000000..f78512f
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/leds/leds-ktd2692.txt
>> @@ -0,0 +1,33 @@
>> +* Kinetic Technologies - KTD2692 Flash LED Driver
>> +
>> +KTD2692 is the ideal power solution for high-power flash LEDs.
>> +It uses ExpressWire single-wire programming for maximum flexibility.
>> +
>> +The ExpressWire interface through CTRL pin can control LED on/off and
>> +enable/disable the IC, Movie(max 1/3 of Flash current) / Flash mode current,
>> +Flash timeout, LVP(low voltage protection).
>> +
>> +Also, When the AUX pin is pulled high while CTRL pin is high,
>> +LED current will be ramped up to the flash-mode current level.
>> +
>> +Required properties:
>> +    - compatible: "kinetic,ktd2692"
>> +    - ctrl-gpio, aux-gpio : gpio pins in order control ktd2692 flash led.
>> +        There is an internal 300kOhm pull-down resistor at each pin
>> +    - vin-supply : "vin" LED supply (2.7V to 5.5V)
>> +        See Documentation/devicetree/bindings/regulator/regulator.txt
>> +
> 
> Above bindings are not that readable to me. Remove the tab spaces before properties.
> 

Isn't it clear?
OK, I'll fix it more

>> +Optional property:
>> +    - flash-timeout-us : Maximum flash timeout in microseconds.
>> +            flash timeout ranges from 0 to 1835000us and
>> +            default is 1049000us.
>> +
>> +Example:
>> +
>> +flash-led {
>> +    compatible = "kinetic,ktd2692";
>> +    ctrl-gpio = <&gpc0 1 0>;
>> +    aux-gpio = <&gpc0 2 0>;
>> +    flash-timeout-us = <1835000>;
>> +    vin-supply = <&vbat>;
>> +};
> 
> 
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/