Re: [PATCH] IIO: Adds ACPI support for ST gyroscopes

[Linus Walleij]

On Fri, Mar 27, 2015 at 11:06 AM, Mika Westerberg
<mika.westerberg@xxxxxxxxxxxxxxx> wrote:
> On Thu, Mar 26, 2015 at 06:28:19PM +0200, Octavian Purdila wrote:

>> For the sleep case I think the GPIO controller needs to do the pin
>> enable and set input direction operation in it's irq_bus_sync_unlock.
>
> I wonder how DT handles all this? Is it the boot firmware that sets up
> the pins accordingly or is there something we are missing?

DT systems mostly do not have firmware for power usecases, they
handle it all using pin control. I would more say that is a feature of
all-SW systems without power-firmware ideas, without ACPI and
without PSCI (well PSCI systems do not care about much more
than CPU power down in firmware anyway...)

Sometimes the power-down/up path includes driving pins to
GND using the generic pin config option PIN_CONFIG_OUTPUT to
drive the logic.

For details on this mess where HW designers think that low-power
sleep mode is "GPIO-something" see Documentation/pinctrl.txt
section named "GPIO mode pitfalls". I..e the question is not what
registers are involved and what these are named, but the actual
usecase.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/