Re: [PATCHv6 04/10] fbdev: ssd1307fb: Unify init code and obtain hw specific bits from DT

[Maxime Ripard]

On Tue, Mar 31, 2015 at 08:27:10PM +0200, Thomas Niederprüm wrote:
> The 130X controllers are very similar from the configuration point of view.
> The configuration registers for the SSD1305/6/7 are bit identical (except the
> the VHCOM register and the the default values for clock setup register). This
> patch unifies the init code of the controller and adds hardware specific
> properties to DT that are needed to correctly initialize the device.
> 
> The SSD130X can be wired to the OLED panel in various ways. Even for the
> same controller this wiring can differ from one display module to another
> and can not be probed by software. The added DT properties reflect these
> hardware decisions of the display module manufacturer.
> The 'com-sequential', 'com-lrremap' and 'com-invdir' values define different
> possibilities for the COM signals pin configuration and readout direction
> of the video memory. The 'segment-no-remap' allows the inversion of the
> memory-to-pin mapping ultimately inverting the order of the controllers
> output pins. The 'prechargepX' values need to be adapted according to the
> capacitance of the OLEDs pixel cells.
> 
> So far these hardware specific bits are hard coded in the init code, making
> the driver usable only for one certain wiring of the controller. This patch
> makes the driver usable with all possible hardware setups, given a valid hw
> description in DT. If these values are not set in DT the default values,
> as they are set in the ssd1307 init code right now, are used. This implies
> that without the corresponding DT property "segment-no-remap" the segment
> remap of the ssd130X controller gets activated. Even though this is not the
> default behaviour according to the datasheet it maintains backward
> compatibility with older DTBs.
> 
> Note that the SSD1306 does not seem to be using the configuration written to
> the registers at all. Therefore this patch does not try to maintain these
> values without changes in DT. For reference an example is added to the DT
> bindings documentation that reproduces the configuration that is set in the
> current init code.
> 
> Signed-off-by: Thomas Niederprüm <niederp@xxxxxxxxxxxxxxxx>
> Tested-by: Olliver Schinagl <o.schinagl@xxxxxxxxxxxxx>

Acked-by: Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx>

Thanks!
Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com

Attachment: signature.asc
Description: Digital signature