Re: not syncing: Attempted to kill init! exitcode=0x00000004 ?

[Masahiro Yamada]

Hi Arnd,

2015-04-07 21:22 GMT+09:00 Arnd Bergmann <arnd@xxxxxxxx>:
> On Tuesday 07 April 2015 17:22:32 Masahiro Yamada wrote:
>> Hi Arnd,
>>
>> Thanks for your comment!
>>
>> 2015-04-07 16:41 GMT+09:00 Arnd Bergmann <arnd@xxxxxxxx>:
>> > On Tuesday 07 April 2015 12:34:30 Masahiro Yamada wrote:
>> >>
>> >> What is the cause of the kernel panic?  How to fix it?
>> >> Any hint is very appreciated.
>> >>
>> >
>> > Cortex-A9 usually need to set up the L2 Cache controller, and you
>> > don't have a node for that.
>> >
>> > Can you try adding a DT node for it? You may also have to specify
>> > the overrides for its aux control register in DT if that is not
>> > set up right by the boot loader or the power-on defaults.
>>
>> I have not checked the L2 (outer) cache yet.
>>
>> The L2 cache on our SoC is not a famous IP, but our own implementation.
>> I will have to implement L2 code as well as the device tree node.
>> Is there any workaround to boot Linux without L2 cache?
>
> It should work normally, I think the only dangerous combination is
> when the L2 controller is enabled but not configured correctly.

OK, I must check this area.

> It's also quite likely that there is some other problem with your
> user space image. Are you able to boot the same image inside of
> qemu or on another hardware that is supported with multi_v7_defconfig?

Yes, I have a Zynq Zedboard.

It successfully boots Linux with the same kernel image and initramdisk.



-- 
Best Regards
Masahiro Yamada
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/