Re: [PATCH V2] drivers/rtc/rtc-ds1307.c: Enable the mcp794xx alarm after programming time

[Alexandre Belloni]

On 21/04/2015 at 20:59:15 -0500, Nishanth Menon wrote :
> >> Why is that so? when set alarm is requested for time X, you want
> >> interrupt at time X, not an interrupt for previous configured RTC
> >> alarm time!
> >>
> > 
> > You expect at least an interrupt.
> 
> And you will get an interrupt if the event occurs before the i2c burst
> starts. Once the i2cburst does start, you are committing to the new time.
> 

You mean that even if ALM0EN is set after ALM0IF was set to 1, it will
trigger the interrupt? I had a look at the MFP output block diagram
would let me think that this is the case. I was thinking otherwise
before. If that is so, then indeed, your patch is OK.

My concern was about the time between ds1307->write_block_data() and
i2c_smbus_write_byte_data() which actually calls cond_sched().

I fully agree that your patch doesn't change the behaviour for the other
cases you presented and further clean up is to be done in a separate set
of patches.

-- 
Alexandre Belloni, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/