Re: [PATCH v6 1/3] nand: pl353: Add basic driver for arm pl353 smc nand interface

From: Ben Shelton
Date: Tue Apr 28 2015 - 11:48:09 EST


Hi Punnaiah,

On 04/13, Punnaiah Choudary Kalluri wrote:
> Add driver for arm pl353 static memory controller nand interface with
> HW ECC support. This controller is used in xilinx zynq soc for interfacing
> the nand flash memory.
>
> Signed-off-by: Punnaiah Choudary Kalluri <punnaia@xxxxxxxxxx>

[...]

> +
> +static int pl353_nand_init_timing(struct device *dev, int mode)
> +{
> + const struct nand_sdr_timings *time;
> + u32 t_rc, t_wc, t_rea, t_wp, t_clr, t_ar, t_rr;
> + ulong clkrate;
> +
> + time = onfi_async_timing_mode_to_sdr_timings(mode);
> + if (IS_ERR(time))
> + return PTR_ERR(time);
> +
> + clkrate = pl353_smc_get_clkrate(dev);
> + t_rc = get_cyc_from_ns(clkrate, time->tRC_min / 1000);
> + t_wc = get_cyc_from_ns(clkrate, time->tWC_min / 1000);
> + t_rea = get_cyc_from_ns(clkrate, time->tREA_max / 1000);
> + t_wp = get_cyc_from_ns(clkrate, time->tWP_min / 1000);
> + t_clr = get_cyc_from_ns(clkrate, time->tCLR_min / 1000);
> + t_ar = get_cyc_from_ns(clkrate, time->tAR_min / 1000);
> + t_rr = get_cyc_from_ns(clkrate, time->tRR_min / 1000);

I tested this patch set in conjunction with your PL353 SMC patch set.

Our first stage bootloader sets the SMC memclk rate to 166.6 MHz, which leads
this code to calculate a t_rc and t_wc of 17 cycles for ONFI mode 0. As I
mentioned in my response to your SMC patch, this overflows the 4-bit-wide
register fields in the SMC that hold these values.

Could we somehow set it up so the NAND and SMC drivers work together to adjust
the memclk rate, if necessary, to achieve the desired timings? Or is there a
better way to handle this?

> +
> + pl353_smc_set_cycles(dev, t_rc, t_wc, t_rea, t_wp, t_clr, t_ar, t_rr);
> +
> + return 0;
> +}

Thanks,
Ben
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/