On Thu, Apr 30, 2015 at 06:18:26PM +0100, Srinivas Kandagatla wrote:I have got very limited access to documentation, which obviously does not have any info related to channel capabilities. I was thinking that all the playback ports support multi-channel. I might be wrong though.
This patch adds bindings for apq8016 machine driver.
On APQ8016 4 MI2S can be configured to different sinks like internal
codec/external codec, this connection is controlled via 2 iomux
registers.
+sound: sound {
+ compatible = "qcom,apq8016-sndcard";
+ reg = <0x07702000 0x4>, <0x07702004 0x4>;
+ reg-names = "mic-iomux", "spkr-iomux";
+ qcom,model = "DB410c";
+
+ /* I2S - Internal codec */
+ internal-dai-link@0 {
+ cpu { /* PRIMARY */
+ sound-dai = <&lpass MI2S_PRIMARY>;
+ };
+ codec {
+ sound-dai = <&wcd_codec 0>;
+ };
+ };
+
+ /* External Primary or External Secondary -ADV7533 HDMI */
+ external-dai-link@0 {
+ external;
+ cpu { /* QUAT */
+ sound-dai = <&lpass MI2S_QUATERNARY>;
+ };
+ codec {
+ sound-dai = <&adv_bridge 0>;
+ };
+ };
+};
OK, although I will need to double-check this with the spec, it seems
(from the patches) that there are 4 I2S ports, 2 of which are being
used. Usually, multi-channel audio is sent to the primary dai (which
is MI2S), which then gets sent to the other ports by HW. If that holds
true for this SOC, then the external cpu dai should be labelled I2S,
not MI2S. If not, then both should be labelled as I2S (and the DAI
channel constraints should be reduced to 1-2).
Looking at patch 12, the internal DAI is labelled Headset and theThis naming is very specific to the SBC board.
external DAI is labelled HDMI.
I2S port can handle multi-channel.External HDMI bridge on the other side only supports 2-channels, but if you can re-check on the channel capabilities would be good.
--