[PATCH v2] clk: qcom: Use parent rate when set rate to pixel RCG clock

[Hai Li]

Since the parent rate has been recalculated, pixel RCG clock
should rely on it to find the correct M/N values during set_rate,
instead of calling __clk_round_rate() to its parent again.

v2: Rebase on clk-next and avoid build warning

Signed-off-by: Hai Li <hali@xxxxxxxxxxxxxx>
Tested-by: Archit Taneja <architt@xxxxxxxxxxxxxx>
Fixes: 99cbd064b059 ("clk: qcom: Support display RCG clocks")
Signed-off-by: Stephen Boyd <sboyd@xxxxxxxxxxxxxx>
---
 drivers/clk/qcom/clk-rcg2.c | 9 +++------
 1 file changed, 3 insertions(+), 6 deletions(-)

diff --git a/drivers/clk/qcom/clk-rcg2.c b/drivers/clk/qcom/clk-rcg2.c
index b95d17f..92936f0 100644
--- a/drivers/clk/qcom/clk-rcg2.c
+++ b/drivers/clk/qcom/clk-rcg2.c
@@ -530,19 +530,16 @@ static int clk_pixel_set_rate(struct clk_hw *hw, unsigned long rate,
 	struct clk_rcg2 *rcg = to_clk_rcg2(hw);
 	struct freq_tbl f = *rcg->freq_tbl;
 	const struct frac_entry *frac = frac_table_pixel;
-	unsigned long request, src_rate;
+	unsigned long request;
 	int delta = 100000;
 	u32 mask = BIT(rcg->hid_width) - 1;
 	u32 hid_div;
-	int index = qcom_find_src_index(hw, rcg->parent_map, f.src);
-	struct clk *parent = clk_get_parent_by_index(hw->clk, index);
 
 	for (; frac->num; frac++) {
 		request = (rate * frac->den) / frac->num;
 
-		src_rate = __clk_round_rate(parent, request);
-		if ((src_rate < (request - delta)) ||
-			(src_rate > (request + delta)))
+		if ((parent_rate < (request - delta)) ||
+			(parent_rate > (request + delta)))
 			continue;
 
 		regmap_read(rcg->clkr.regmap, rcg->cmd_rcgr + CFG_REG,
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
hosted by The Linux Foundation

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/