[PATCH-v3 02/11] i2c: pxa: No need to set slave addr for i2c master mode reset

[Vaibhav Hiremath]

Normally i2c controller works as master, so slave addr is not needed, or it
will impact some slave device (eg. ST NFC chip) i2c accesses, because it has
the same i2c address with controller.

Signed-off-by: Jett.Zhou <jtzhou@xxxxxxxxxxx>
Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath@xxxxxxxxxx>
Acked-by: Robert Jarzmik <robert.jarzmik@xxxxxxx>
---
 drivers/i2c/busses/i2c-pxa.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/i2c/busses/i2c-pxa.c b/drivers/i2c/busses/i2c-pxa.c
index f4ac8c5..023e59f 100644
--- a/drivers/i2c/busses/i2c-pxa.c
+++ b/drivers/i2c/busses/i2c-pxa.c
@@ -459,7 +459,7 @@ static void i2c_pxa_reset(struct pxa_i2c *i2c)
 	writel(I2C_ISR_INIT, _ISR(i2c));
 	writel(readl(_ICR(i2c)) & ~ICR_UR, _ICR(i2c));
 
-	if (i2c->reg_isar)
+	if (i2c->reg_isar && IS_ENABLED(CONFIG_I2C_PXA_SLAVE))
 		writel(i2c->slave_addr, _ISAR(i2c));
 
 	/* set control register values */
-- 
1.9.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/