Re: [PATCH v3 5/5] arm: qcom: dts: Enable NAND node on IPQ8064 AP148 platform

[Archit Taneja]

On 8/4/2015 2:28 AM, Stephen Boyd wrote:
> On 08/03, Archit Taneja wrote:
> > @@ -93,5 +115,19 @@
> >   		sata@29000000 {
> >   			status = "ok";
> >   		};
> > +
> > +		nand@1ac00000 {
> > +			status = "ok";
> > +
> > +			pinctrl-0 = <&nand_pins>;
> > +			pinctrl-names = "default";
> > +
> > +			nand-ecc-strength = <4>;
> > +			nand-bus-width = <8>;
> > +		};
> >   	};
> >   };
> > +
> > +&adm_dma {
> > +	status = "ok";
> > +};
>
> I think the preference is to put the full path to the device in
> the dts file and then have status = "ok". So please move this
> into the soc node and give the correct offset, etc. like we've
> done for other nodes.

I'll do that.

Archit

--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/