Re: [PATCH 3/3] serial: 8250: omap: restore registers on shutdown

[Peter Hurley]

On 08/06/2015 09:59 AM, Sebastian Andrzej Siewior wrote:
> On 08/06/2015 02:31 PM, Sebastian Andrzej Siewior wrote:
> 
> Hi Peter,
> 
>>> I'll look at/test this this weekend, ok?
>>
>> Sure. I'm currently re-spinning the patches so have everything in
>> proper pieces. While at it I will take a look at x_char.
> 
> So now that I actually look at it. If I read this right, we never send
> the x_char if the TX-DMA never fails to do its job.

That's what I saw too; almost all the dma drivers are broken wrt x_char.
The amba-pl011 driver gets it right.

> The comment above uart_send_xchar() says it is high priority.

'High' priority is meant relative to previously written data which has
not yet been sent.

> What do you suggest, wait
> until the transfer completes, send the x_char _or_ pause the transfer
> send that byte and then send the byte?

'Better' would be sending the x_char when the current dma transfer
completes. However, it will probably have /some/ impact on what line
rates software flow control can be used. Worst case @ 115Kbaud is 35ms
delay in sending.

'Best' would be pausing the dma and sending the byte. However, I'm not
even sure if this is possible on OMAP; the TRM is woefully under-documented
in that regard.

> In both cases we have to wait until for the FIFO-empty interrupt to
> make sure we don't overrun that TX-FIFO.
> 
> I *think* waiting until the transfer completes would be simpler but it
> is not necessarily high priority.

I agree; this is what we should do first because someone might want it
for backports.

Regards,
Peter Hurley
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/