Re: [PATCH v4 2/2] serial: mxs-auart: keep the AUART unit in reset state when not in use

[Peter Hurley]

On 08/07/2015 06:47 AM, Juergen Borleis wrote:
> Whenever the UART device driver gets closed from userland, the driver
> disables the UART unit and then stops the clocks to save power.
> 
> The bit which disabled the UART unit is described as:
> 
>  "UART Enable. If this bit is set to 1, the UART is enabled. Data
>   transmission and reception occurs for the UART signals. When the
>   UART is disabled in the middle of transmission or reception, it
>   completes the current character before stopping."
> 
> The important part is the "it completes the current character". Whenever
> a reception is ongoing when the UART gets disabled (including the clock
> off) the statemachine freezes and "remembers" this state on the next
> open() when re-enabling the unit's clock.
> 
> In this case we end up receiving an additional bogus character
> immediately.
> 
> The solution in this change is to switch the AUART unit into its reset
> state on close() and only release it from its reset state on the next
> open().
> 
> Note: when the unit is also used as system console it is always 'in use',
> so we cannot reset it on close().

The code is still a bit ackward but looks functional, so

Reviewed-by: Peter Hurley <peter@xxxxxxxxxxxxxxxxxx>


PS - This mxs driver has the same problem as the i.MX driver.
     The irq request and hardware init should be done in startup().

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/