[PATCH] net: stmmac: Use msleep rather then udelay for reset delay

[Sjoerd Simons]

The reset delays used for stmmac are in the order of 10ms to 1 second,
which is far too long for udelay usage, so switch to using msleep.

Practically this fixes the PHY not being reliably detected in some cases
as udelay wouldn't actually delay for long enough to let the phy
reliably be reset.

Signed-off-by: Sjoerd Simons <sjoerd.simons@xxxxxxxxxxxxxxx>
---

 drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c | 11 ++++++++---
 1 file changed, 8 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
index b735fa2..17fa588 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
@@ -161,11 +161,16 @@ int stmmac_mdio_reset(struct mii_bus *bus)
 
 		if (!gpio_request(reset_gpio, "mdio-reset")) {
 			gpio_direction_output(reset_gpio, active_low ? 1 : 0);
-			udelay(data->delays[0]);
+			if (data->delays[0])
+				msleep((data->delays[0] + 999) / 1000);
+
 			gpio_set_value(reset_gpio, active_low ? 0 : 1);
-			udelay(data->delays[1]);
+			if (data->delays[1])
+				msleep((data->delays[1] + 999) / 1000);
+
 			gpio_set_value(reset_gpio, active_low ? 1 : 0);
-			udelay(data->delays[2]);
+			if (data->delays[2])
+				msleep((data->delays[2] + 999) / 1000);
 		}
 	}
 #endif
-- 
2.5.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/