Re: [PATCH V2 1/2] Documentation: DT: Add binding documentation for NVIDIA ADMA

[Jon Hunter]

On 07/10/15 00:04, Stephen Warren wrote:
> On 10/05/2015 06:10 AM, Jon Hunter wrote:
>> Add device-tree binding documentation for the Tegra210 Audio DMA
>> controller.
> 
>> diff --git a/Documentation/devicetree/bindings/dma/tegra210-adma.txt
>> b/Documentation/devicetree/bindings/dma/tegra210-adma.txt
> 
>> +- #dma-cells : Must be <2>. The first cell denotes the transmit or
>> +  receive request number and should be between 1 and the maximum number
>> +  of requests supported (see properties "dma-rx-requests" and
>> +  "dma-tx-requests"). This value corresponds to the RX/TX_REQUEST_SELECT
>> +  fields in the ADMA_CHn_CTRL register. The second cell denotes whether
>> +  the channel is a receive or transmit channel and must be either 2 for
>> +  a receive channel and 4 for a transmit channel. These values
>> correspond
>> +  to the TRANSFER_DIRECTION field of the ADMA_CHn_CTRL register.
> 
> Is it typical to encode the direction into the dma cells? I would have
> thought the client would provide that information at run-time when
> requesting a DMA channel.

I have seen other dma bindings that do [0]. If we don't put the
direction in the client binding, then it would appear as ...

tegra_admaif: admaif@0x702d0000 {
    ...
    dmas = <&adma 1>, <&adma 1>, <&adma 2>, <&adma 2>,
           <&adma 3>, <&adma 3>, <&adma 4>, <&adma 4>,
           <&adma 5>, <&adma 5>, <&adma 6>, <&adma 6>,
           <&adma 7>, <&adma 7>, <&adma 8>, <&adma 8>,
           <&adma 9>, <&adma 9>, <&adma 10>, <&adma 10>;
    dma-names = "rx1", "tx1", "rx2", "tx2", "rx3", "tx3",
                "rx4", "tx4", "rx5", "tx5", "rx6", "tx6",
                "rx7", "tx7", "rx8", "tx8", "rx9", "tx9",
                "rx10", "tx10";
    ...
};

... where "rxN" and "txN" appear to use the same request, but the
reality is that "rxN" is using rx-request-N and "txN" is using
tx-request-N. Arnd questioned this before. Obviously I can explain this
in the binding document if the above is preferred. However, given that
they are named "rx1", "rx2", etc, why not put the direction in the binding?

By the way, in the ADMA driver, the driver does check that the direction
specified when configuring the transfer (ie. via
tegra_adma_prep_dma_cyclic()) matches the adma channel being used.

Cheers
Jon

[0]
http://git.kernel.org/cgit/linux/kernel/git/torvalds/linux.git/tree/Documentation/devicetree/bindings/dma/ste-dma40.txt
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/