Re: [PATCH v2 1/4] dt-bindings: Document the STM32 DMA bindings

[M'boumba Cedric Madianga]

Hi Mark,

> +5. A 32bit mask specifying the DMA FIFO configuration
> + -bit 0-1: Fifo threshold
> +       0x0: 1/4 full FIFO
> +       0x1: 1/2 full FIFO
> +       0x2: 3/4 full FIFO
> +       0x3:full FIFO
> + -bit 2: Direct mode
> +       0x0: enabled
> +       0x1: disabled
> +
Finally, I find a way to handle the above inputs outside DT.
So, I will remove it from DT in the next version.
Thanks.

To sum-up, the remaining information that the client will have to
specify from DT are describing below.
Is it ok ?
> + -bit 9: Peripheral Increment Address
> +       0x0: no address increment between transfers
> +       0x1: increment address between transfers
> + -bit 10: Memory Increment Address
> +       0x0: no address increment between transfers
> +       0x1: increment address between transfers
> + -bit 15: Peripheral Increment Offset Size
> +       0x0: offset size is linked to the peripheral bus width
> +       0x1: offset size is fixed to 4 (32-bit alignment)
> + -bit 16-17: Priority level
> +       0x0: low
> +       0x1: medium
> +       0x2: high
> +       0x3: very high

BR,
Cedric
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/