Re: [RESEND PATCH v2 1/2] dt-bindings: rockchip-thermal: Add the "init" pinctrl in this document

From: Doug Anderson
Date: Wed Oct 21 2015 - 23:46:29 EST


Caesar,

On Wed, Oct 21, 2015 at 7:30 PM, Caesar Wang <wxt@xxxxxxxxxxxxxx> wrote:
> The "init" pinctrl is defined we'll set
> pinctrl to this state before probe and then "default" after probe.
>
> Add the "init" pinctrl as the OTP gpio state, since we need switch
> the pin to gpio state before the TSADC controller is reset.
>
> As I know, the TSADC controller is reset, the tshut polarity will be
> a *low* signal in a short period of time for some devices.
>
> Says:
> The TSADC get the temperature on rockchip thermal.
>
> If T(current temperature) < (setting temperature), the OTP output the
> *high* signal.
> If T(current temperature) > (setting temperature), the OTP output the
> *low* Signal.
>
> In some cases, the OTP pin is connected to the PMIC, maybe the
> PMIC can accept the reset response time to avoid this issue.
>
> In other words, the system will be always reboot if we make the
> OTP pin is connected the others IC to control the power.
>
> Signed-off-by: Caesar Wang <wxt@xxxxxxxxxxxxxx>
> Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
> ---
>
> Changes in v2:
> - Add the 'init' pinctrl more decription in commit.
> - Fix the subject to make more obvious in PATCH[1/2]
> - Resend this patch v2 since fix the subject to be specific.
>
> Changes in v1:
> - As the Doug comments, add the 'init' property to sync document.
>
> Documentation/devicetree/bindings/thermal/rockchip-thermal.txt | 5 +++--
> 1 file changed, 3 insertions(+), 2 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt b/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt
> index ef802de..28e84f7 100644
> --- a/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt
> +++ b/Documentation/devicetree/bindings/thermal/rockchip-thermal.txt

I think Rob wanted something more in the "rockchip-thermal.txt"
document itself. Like:

Pinctrl states:
- During device probe a driver may glitch the output line. If this is
not acceptable for your board, you can use the standard "init" and
"default" pinctrl states. The "init" state will be set before device
probe and "default" after.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/