Re: [PATCH 1/2] can: xilinx: use readl/writel instead of ioread/iowrite

[Marc Kleine-Budde]

On 10/22/2015 10:14 AM, Arnd Bergmann wrote:
> On Thursday 22 October 2015 10:16:02 Kedareswara rao Appana wrote:
>> The driver only supports memory-mapped I/O [by ioremap()],
>> so readl/writel is actually the right thing to do, IMO.
>> During the validation of this driver or IP on ARM 64-bit processor
>> while sending lot of packets observed that the tx packet drop with iowrite
>> Putting the barriers for each tx fifo register write fixes this issue
>> Instead of barriers using writel also fixed this issue.
>>
>> Signed-off-by: Kedareswara rao Appana <appanad@xxxxxxxxxx>
> 
> The two should really do the same thing: iowrite32() is just a static inline
> calling writel() on both ARM32 and ARM64. On which kernel version did you
> observe the difference? It's possible that an older version used
> CONFIG_GENERIC_IOMAP, which made this slightly more expensive.
> 
> If there are barriers that you want to get rid of for performance reasons,
> you should use writel_relaxed(), but be careful to synchronize them correctly
> with regard to DMA. It should be fine in this driver, as it does not
> perform any DMA, but be aware that there is no big-endian version of
> writel_relaxed() at the moment.

We don't have DMA in CAN drivers, but usually a certain write triggers
sending. Do we need a barrier before triggering the sending?

Marc

-- 
Pengutronix e.K.                  | Marc Kleine-Budde           |
Industrial Linux Solutions        | Phone: +49-231-2826-924     |
Vertretung West/Dortmund          | Fax:   +49-5121-206917-5555 |
Amtsgericht Hildesheim, HRA 2686  | http://www.pengutronix.de   |

Attachment: signature.asc
Description: OpenPGP digital signature