[PATCHv2] ixgbe: Wait for 1ms, not 1us, after RST

[Dan Streetman]

The driver currently waits 1us after issuing a RST, but the spec
requires it to wait 1ms.  This adds a msleep(1) before polling the
reset bit.

Signed-off-by: Dan Streetman <dan.streetman@xxxxxxxxxxxxx>
Signed-off-by: Dan Streetman <ddstreet@xxxxxxxx>
---
changes since v1:
 use msleep(1) instead of mdelay(1), per Peter Hurley
 move msleep(1) out of for loop - only msleep once, leave udelay(1)
   inside for loop
 use spec sec title instead of number, per Don Skidmore

 drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c
index 4e75843..02cfa1e 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_x540.c
@@ -111,6 +111,13 @@ mac_reset_top:
 	IXGBE_WRITE_REG(hw, IXGBE_CTRL, ctrl);
 	IXGBE_WRITE_FLUSH(hw);
 
+	/* From the spec "General Control Registers - Device Control Register":
+	 * "...programmers must wait approximately 1 ms after setting before
+	 *  attempting to check if the bit has cleared or to access (read
+	 *  or write) any other device register."
+	 */
+	msleep(1);
+
 	/* Poll for reset bit to self-clear indicating reset is complete */
 	for (i = 0; i < 10; i++) {
 		udelay(1);
-- 
2.5.0

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/