Re: [PATCH v3 2/5] mfd: syscon: add a DT property to set value width

[Arnd Bergmann]

On Tuesday 17 November 2015 09:26:49 Guenter Roeck wrote:
> > 
> > This syntax is confusing, as we normally associate it with an error
> > condition.  Instead, I'd use:
> > 
> >   if (of_property_read_u32(np, "bus-width", &bus_width) == 0)
> 
> Or maybe better
> 
>         if (!of_property_read_u32(np, "bus-width", &bus_width))

I would also prefer the latter, but it doesn't matter much either way.

> > 
> > Or, for more clarity:
> > 
> >   of_property_read_u32(np, "bus-width", &bus_width);
> >   if (bus_width)
> > 
> > If you choose this version (which I think is my preferred method, don't
> > forget to initialise 'bus_width' to zero.
> > 
> Ignoring an error and depending on bus_width==0 to determine if the property
> was provided seems odd, especially since it would "hide" if the bus-width
> property is set to 0. In the original code, this would be detected as error.

Right.

Another option would be

	ret = of_property_read_u32(np, "bus-width", &bus_width);
	/* no bus width provided, default to 32-bit */
	if (ret)
		bus_width = 32;

	syscon_config.val_bits = bus_width;
	syscon_config.reg_stride = syscon_config.val_bits / 8;

which has the same effect but seems a little clearer to me.

	Arnd
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/