[PATCH 04/13] net: mvneta: enable suspend/resume support

[Marcin Wojtas]

This commit introduces suspend/resume routines used for both in 'standby'
and 'mem' modes. For the latter, in which registers' contents are lost,
following steps are performed:
* in suspend - update port statistics and, if interface is running,
  detach netif, clean the queues, disable cpu notifier, shutdown
  interface and reset port's link status;
* in resume, for all interfaces, set default configuration of the port and
  MBUS windows;
* in resume, in case the interface is running, enable accepting packets in
  legacy parser, power up the port, register cpu notifier and attach netif.

Signed-off-by: Marcin Wojtas <mw@xxxxxxxxxxxx>
---
 drivers/net/ethernet/marvell/mvneta.c | 70 +++++++++++++++++++++++++++++++++++
 1 file changed, 70 insertions(+)

diff --git a/drivers/net/ethernet/marvell/mvneta.c b/drivers/net/ethernet/marvell/mvneta.c
index d12b8c6..f079b13 100644
--- a/drivers/net/ethernet/marvell/mvneta.c
+++ b/drivers/net/ethernet/marvell/mvneta.c
@@ -3442,6 +3442,72 @@ static int mvneta_remove(struct platform_device *pdev)
 	return 0;
 }
 
+#ifdef CONFIG_PM_SLEEP
+static int mvneta_suspend(struct platform_device *pdev, pm_message_t state)
+{
+	struct net_device *dev = platform_get_drvdata(pdev);
+	struct mvneta_port *pp = netdev_priv(dev);
+
+	mvneta_ethtool_update_stats(pp);
+
+	if (!netif_running(dev))
+		return 0;
+
+	netif_device_detach(dev);
+
+	mvneta_stop_dev(pp);
+	unregister_cpu_notifier(&pp->cpu_notifier);
+	mvneta_cleanup_rxqs(pp);
+	mvneta_cleanup_txqs(pp);
+
+	/* Reset link status */
+	pp->link = 0;
+	pp->duplex = -1;
+	pp->speed = 0;
+
+	return 0;
+}
+
+static int mvneta_resume(struct platform_device *pdev)
+{
+	const struct mbus_dram_target_info *dram_target_info;
+	struct net_device *dev = platform_get_drvdata(pdev);
+	struct mvneta_port *pp = netdev_priv(dev);
+	int ret;
+
+	mvneta_defaults_set(pp);
+	mvneta_port_power_up(pp, pp->phy_interface);
+
+	dram_target_info = mv_mbus_dram_info();
+	if (dram_target_info)
+		mvneta_conf_mbus_windows(pp, dram_target_info);
+
+	if (!netif_running(dev))
+		return 0;
+
+	ret = mvneta_setup_rxqs(pp);
+	if (ret) {
+		netdev_err(dev, "unable to setup rxqs after resume\n");
+		return ret;
+	}
+
+	ret = mvneta_setup_txqs(pp);
+	if (ret) {
+		netdev_err(dev, "unable to setup txqs after resume\n");
+		return ret;
+	}
+
+	mvneta_set_rx_mode(dev);
+	mvneta_percpu_elect(pp);
+	register_cpu_notifier(&pp->cpu_notifier);
+	mvneta_start_dev(pp);
+
+	netif_device_attach(dev);
+
+	return 0;
+}
+#endif /* CONFIG_PM_SLEEP */
+
 static const struct of_device_id mvneta_match[] = {
 	{ .compatible = "marvell,armada-370-neta" },
 	{ .compatible = "marvell,armada-xp-neta" },
@@ -3452,6 +3518,10 @@ MODULE_DEVICE_TABLE(of, mvneta_match);
 static struct platform_driver mvneta_driver = {
 	.probe = mvneta_probe,
 	.remove = mvneta_remove,
+#ifdef CONFIG_PM_SLEEP
+	.suspend = mvneta_suspend,
+	.resume = mvneta_resume,
+#endif
 	.driver = {
 		.name = MVNETA_DRIVER_NAME,
 		.of_match_table = mvneta_match,
-- 
1.8.3.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/