Re: [PATCH 4/10] watchdog: bcm63xx_wdt: Handle hardware interrupt and remove software timer

[Jonas Gorski]

On Tue, Nov 24, 2015 at 7:21 PM, Guenter Roeck <linux@xxxxxxxxxxxx> wrote:
> On Sun, Nov 22, 2015 at 02:05:16PM +0000, Simon Arlott wrote:
>> There is a level triggered interrupt for the watchdog timer as part of
>> the bcm63xx_timer device. The interrupt occurs when the hardware watchdog
>> timer reaches 50% of the remaining time.
>>
>> It is not possible to mask the interrupt within the bcm63xx_timer device.
>> To get around this limitation, handle the interrupt by restarting the
>> watchdog with the current remaining time (which will be half the previous
>> timeout) so that the interrupt occurs again at 1/4th, 1/8th, etc. of the
>> original timeout value until the watchdog forces a reboot.
>>
>> The software timer was restarting the hardware watchdog with a 85 second
>> timeout until the software timer expired, and then causing a panic()
>> about 42.5 seconds later when the hardware interrupt occurred. The
>> hardware watchdog would not reboot until a further 42.5 seconds had
>> passed.
>>
>> Remove the software timer and rely on the hardware timer directly,
>> reducing the maximum timeout from 256 seconds to 85 seconds
>> (2^32 / WDT_HZ).
>>
>
> Florian,
>
> can you have a look into this patch and confirm that there is no better
> way to clear the interrupt status ?

While the watchdog interrupt can't be masked, it should be able to be
cleared by writing 1 to the appropriate bit in the timer block's
interrupt status register. At least the broadcom sources do so.


Jonas
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/