Re: [PATCH 2/2] irqchip: add support for Sigma Designs SMP86xx interrupt controller

[Mason]

On 25/11/2015 13:12, Måns Rullgård wrote:

> Mason writes:
> 
>>> +	status_lo = intc_readl(chip, chip->ctl + IRQ_STATUS);
>>> +	status_hi = intc_readl(chip, chip->ctl + IRQ_CTL_HI + IRQ_STATUS);
>>
>> In my local branch, I wrote:
>>
>> #define IRQ_CTL_LO	0
>>
>> 	status_lo = intc_readl(chip, chip->ctl + IRQ_CTL_LO + IRQ_STATUS);
>> 	status_hi = intc_readl(chip, chip->ctl + IRQ_CTL_HI + IRQ_STATUS);
>>
>> (I'm a sucker for symmetry)
> 
> Nothing wrong with a little symmetry, though in this case I think the
> extra macro only confuses matters.

It's your call :-)

In my mind, the fact that the status_lo register sits at offset 0 is
just an accident. It's just that something has to sit at offset 0.
(Maybe I should tell the HW guys to put nothing at offset 0, and start
the actual register block at offset 4. /That/ would be unexpected.)

Another way to look at it is:

There are two 4-register blocks (LO and HI) each containing registers
{status,rawstat,enableset,enableclr}.

Block LO starts at offset 0x0
Block HI starts at offset 0x18

and then there are the intra offsets for the 4 registers in the block.

There! I got the bike-shedding out of my system ;-)

Regards.

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/