[PATCH (v2) 2/2] regulator: bcm63xx: Add BCM63xx fixed regulator device
From: Simon Arlott
Date: Mon Nov 30 2015 - 15:38:46 EST
The BCM63xx has one or more registers with bits that act as regulators
to enable/disable power to individual chip peripherals.
Signed-off-by: Simon Arlott <simon@xxxxxxxxxxx>
---
On 30/11/15 20:30, Simon Arlott wrote:
> + /* Only status change is supported, regardless of DT init data */
> + init_data->valid_ops_mask &= ~REGULATOR_CHANGE_STATUS;
Sorry, I thought I had tested it again after adding that line.
MAINTAINERS | 1 +
drivers/regulator/Kconfig | 9 +++
drivers/regulator/Makefile | 1 +
drivers/regulator/bcm63xx-regulator.c | 125 ++++++++++++++++++++++++++++++++++
4 files changed, 136 insertions(+)
create mode 100644 drivers/regulator/bcm63xx-regulator.c
diff --git a/MAINTAINERS b/MAINTAINERS
index a381176..29e0589 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -2376,6 +2376,7 @@ F: arch/mips/boot/dts/brcm/bcm*.dts*
F: drivers/irqchip/irq-bcm63*
F: drivers/irqchip/irq-bcm7*
F: drivers/irqchip/irq-brcmstb*
+F: drivers/regulator/bcm63*
F: include/linux/bcm63xx_wdt.h
BROADCOM TG3 GIGABIT ETHERNET DRIVER
diff --git a/drivers/regulator/Kconfig b/drivers/regulator/Kconfig
index 8df0b0e..8a2d5db 100644
--- a/drivers/regulator/Kconfig
+++ b/drivers/regulator/Kconfig
@@ -146,6 +146,15 @@ config REGULATOR_AXP20X
This driver provides support for the voltage regulators on the
AXP20X PMIC.
+config REGULATOR_BCM63XX
+ tristate "Broadcom BCM63xx Regulators"
+ depends on OF
+ depends on MFD_SYSCON
+ depends on BMIPS_GENERIC
+ help
+ This driver provides support for the fixed regulators on the
+ BCM63xx SoCs.
+
config REGULATOR_BCM590XX
tristate "Broadcom BCM590xx PMU Regulators"
depends on MFD_BCM590XX
diff --git a/drivers/regulator/Makefile b/drivers/regulator/Makefile
index 0f81749..23e8a4b 100644
--- a/drivers/regulator/Makefile
+++ b/drivers/regulator/Makefile
@@ -21,6 +21,7 @@ obj-$(CONFIG_REGULATOR_ARIZONA) += arizona-micsupp.o arizona-ldo1.o
obj-$(CONFIG_REGULATOR_AS3711) += as3711-regulator.o
obj-$(CONFIG_REGULATOR_AS3722) += as3722-regulator.o
obj-$(CONFIG_REGULATOR_AXP20X) += axp20x-regulator.o
+obj-$(CONFIG_REGULATOR_BCM63XX) += bcm63xx-regulator.o
obj-$(CONFIG_REGULATOR_BCM590XX) += bcm590xx-regulator.o
obj-$(CONFIG_REGULATOR_DA903X) += da903x.o
obj-$(CONFIG_REGULATOR_DA9052) += da9052-regulator.o
diff --git a/drivers/regulator/bcm63xx-regulator.c b/drivers/regulator/bcm63xx-regulator.c
new file mode 100644
index 0000000..13a0fbc
--- /dev/null
+++ b/drivers/regulator/bcm63xx-regulator.c
@@ -0,0 +1,125 @@
+/*
+ * Copyright 2015 Simon Arlott
+ *
+ * This program is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License as
+ * published by the Free Software Foundation; either version 2 of the
+ * License, or (at your option) any later version.
+ *
+ * Derived from fixed.c:
+ * Copyright 2008 Wolfson Microelectronics PLC.
+ *
+ * Author: Mark Brown <broonie@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
+ *
+ * Copyright (c) 2009 Nokia Corporation
+ * Roger Quadros <ext-roger.quadros@xxxxxxxxx>
+ */
+
+#include <linux/err.h>
+#include <linux/mutex.h>
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/regulator/driver.h>
+#include <linux/slab.h>
+#include <linux/of.h>
+#include <linux/regulator/of_regulator.h>
+#include <linux/regulator/machine.h>
+#include <linux/mfd/syscon.h>
+
+static struct regulator_ops bcm63xx_regulator_ops = {
+ .enable = regulator_enable_regmap,
+ .disable = regulator_disable_regmap,
+ .is_enabled = regulator_is_enabled_regmap,
+};
+
+static int __init bcm63xx_regulator_probe(struct platform_device *pdev)
+{
+ struct device *dev = &pdev->dev;
+ struct device_node *np = dev->of_node;
+ struct regulator_desc *desc;
+ struct regulator_init_data *init_data;
+ struct regulator_config cfg = { };
+ struct regulator_dev *reg_dev;
+ u32 val;
+ int ret;
+
+ desc = devm_kzalloc(dev, sizeof(*desc), GFP_KERNEL);
+ if (!desc)
+ return -ENOMEM;
+
+ init_data = of_get_regulator_init_data(dev, np, desc);
+ if (!init_data) {
+ dev_err(dev, "Failed to get regulator init data\n");
+ return -EINVAL;
+ }
+
+ /* Only status change is supported, regardless of DT init data */
+ init_data->constraints.valid_ops_mask &= REGULATOR_CHANGE_STATUS;
+
+ desc->name = devm_kstrdup(dev, init_data->constraints.name, GFP_KERNEL);
+ if (desc->name == NULL)
+ return -ENOMEM;
+ desc->type = REGULATOR_VOLTAGE;
+ desc->owner = THIS_MODULE;
+ desc->ops = &bcm63xx_regulator_ops;
+
+ /* Clearing a bit in the register enables power */
+ desc->enable_is_inverted = true;
+
+ cfg.dev = dev;
+ cfg.init_data = init_data;
+ cfg.of_node = np;
+
+ cfg.regmap = syscon_regmap_lookup_by_phandle(np, "regmap");
+ if (IS_ERR(cfg.regmap)) {
+ ret = PTR_ERR(cfg.regmap);
+ dev_err(dev, "Failed to get regmap for %s: %d\n",
+ desc->name, ret);
+ return ret;
+ }
+
+ if (of_property_read_u32(np, "offset", &val)) {
+ dev_err(dev, "Missing register offset for %s\n", desc->name);
+ return -EINVAL;
+ }
+ desc->enable_reg = val;
+
+ if (of_property_read_u32(np, "mask", &val)) {
+ dev_err(dev, "Missing register mask for %s\n", desc->name);
+ return -EINVAL;
+ }
+ desc->enable_mask = val;
+
+ if (!of_property_read_u32(np, "startup-delay-us", &val))
+ desc->enable_time = val;
+
+ reg_dev = devm_regulator_register(dev, desc, &cfg);
+ if (IS_ERR(reg_dev)) {
+ ret = PTR_ERR(reg_dev);
+ dev_err(dev, "Failed to register regulator %s: %d\n",
+ desc->name, ret);
+ return ret;
+ }
+
+ return 0;
+}
+
+static const struct of_device_id bcm63xx_regulator_of_match[] __initconst = {
+ { .compatible = "brcm,bcm63xx-regulator", },
+ {},
+};
+MODULE_DEVICE_TABLE(of, bcm63xx_regulator_of_match);
+
+static struct platform_driver bcm63xx_regulator_driver __refdata = {
+ .probe = bcm63xx_regulator_probe,
+ .driver = {
+ .name = "bcm63xx-regulator",
+ .of_match_table = bcm63xx_regulator_of_match,
+ },
+};
+
+module_platform_driver(bcm63xx_regulator_driver);
+
+MODULE_AUTHOR("Simon Arlott");
+MODULE_DESCRIPTION("BCM63xx regulator");
+MODULE_LICENSE("GPL");
--
2.1.4
--
Simon Arlott
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/