[PATCH] mmc: mediatek: change some dev_err to dev_dbg

[Chaotian Jing]

there are too many error logs shown when use CMD21/CMD19 to do tune,
and it will appear at each resume time, print out so many logs to the
uart console cost too mush time. so change it to dev_dbg.

Signed-off-by: Chaotian Jing <chaotian.jing@xxxxxxxxxxxx>
---
 drivers/mmc/host/mtk-sd.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/mmc/host/mtk-sd.c b/drivers/mmc/host/mtk-sd.c
index 39568cc..34d23b8 100644
--- a/drivers/mmc/host/mtk-sd.c
+++ b/drivers/mmc/host/mtk-sd.c
@@ -972,7 +972,7 @@ static bool msdc_data_xfer_done(struct msdc_host *host, u32 events,
 		if ((events & MSDC_INT_XFER_COMPL) && (!stop || !stop->error)) {
 			data->bytes_xfered = data->blocks * data->blksz;
 		} else {
-			dev_err(host->dev, "interrupt events: %x\n", events);
+			dev_dbg(host->dev, "interrupt events: %x\n", events);
 			msdc_reset_hw(host);
 			host->error |= REQ_DAT_ERR;
 			data->bytes_xfered = 0;
@@ -982,10 +982,10 @@ static bool msdc_data_xfer_done(struct msdc_host *host, u32 events,
 			else if (events & MSDC_INT_DATCRCERR)
 				data->error = -EILSEQ;
 
-			dev_err(host->dev, "%s: cmd=%d; blocks=%d",
+			dev_dbg(host->dev, "%s: cmd=%d; blocks=%d",
 				__func__, mrq->cmd->opcode, data->blocks);
-			dev_err(host->dev, "data_error=%d xfer_size=%d\n",
-					(int)data->error, data->bytes_xfered);
+			dev_dbg(host->dev, "data_error=%d xfer_size=%d\n",
+				(int)data->error, data->bytes_xfered);
 		}
 
 		msdc_data_xfer_next(host, mrq, data);
-- 
1.8.1.1.dirty

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/