Re: [PATCH 05/10] ARM: OMAP2+: Disable GPIO softreset for dm81xx

[Tony Lindgren]

* Tony Lindgren <tony@xxxxxxxxxxx> [151201 16:42]:
> * Matthijs van Duin <matthijsvanduin@xxxxxxxxx> [151201 16:11]:
> > On 2 December 2015 at 00:38, Tony Lindgren <tony@xxxxxxxxxxx> wrote:
> > > Looks like GPIO softreset status bit on both dm8168 and dm8148
> > > is broken and only goes high initially. After writing to sysc
> > > softreset bit, the resetdone bit never goes high again.
> > 
> > The resetdone bit works fine, but it needs all clocks active to come
> > up. You're neglecting to enable the debounce clock to the GPIO module:
> > 
> > > # mw.l 0x4818155c 0x2
> > 
> > That should write 0x102 instead.
> 
> It seems to work only once based on what I've seen :) If you try it
> after it's powered it never works. Could be I'm doing something wrong
> of course..
> 
> > You can disable the debounce clock after resetting the module if you
> > don't need it, though I doubt there's any significant power savings
> > there. (More likely it exists as a separate bit to allow it to stay
> > enabled even if the module isn't, for wakeup on debounced inputs.)
> 
> Hmm I tried setting HWMOD_CONTROL_OPT_CLKS_IN_RESET flag like we
> have for many SoCs to enable also sysclk18_ck but no luck. I can
> recheck that.

You're right with 0x102 it works, need to debug further.

Thanks,

Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/