Re: [PATCH v2] extcon: add Maxim MAX3355 driver

[Sergei Shtylyov]

Hello.

On 12/15/2015 2:44 AM, Greg KH wrote:

> > > > > > Maxim  Integrated MAX3355E chip integrates a  charge pump and comparators
> > > > > > to
> > > > > > enable a system with an integrated USB OTG dual-role transceiver to
> > > > > > function
> > > > > > as  an USB  OTG dual-role device.  In addition  to sensing/controlling
> > > > > > Vbus,
> > > > > > the chip also passes thru the ID signal  from the USB  OTG connector.
> > > > > > On some Renesas boards,  this signal is  just fed into the SoC thru a
> > > > > > GPIO
> > > > > > pin --  there's no real  OTG controller, only host and gadget USB
> > > > > > controllers
> > > > > > sharing the same USB bus; however, we'd  like to allow host or gadget
> > > > > > drivers
> > > > > > to be loaded depending on the cable type,  hence the need for the MAX3355
> > > > > > extcon driver. The Vbus status signals are also  wired to GPIOs (however,
> > > > > > we
> > > > > > aren't currently interested in them),  the OFFVBUS# signal is controlled
> > > > > > by
> > > > > > the host controllers, there's  also the SHDN# signal wired to a GPIO, it
> > > > > > should be driven high for the  normal operation.
> > > > >
> > > > >
> > > > > As multiple people have said, fix the spacing here.
> > > >
> > > >
> > > >     You are the first to complain abou _this_ patch. If you don't have other
> > > > issues with this driver in which case you should have trimmed the reply at
> > > > this point), I'd like to keep my spacing as is. Thank you.
> > >
> > > Your previous version was not "extcon-usb-gpio: add enable pin
> > > support"[1] which has now been re-written to be max3355 specific?
> >
> >     No, the MAX3355 driver pre-dates that version. First there was a driver,
> > then I tried to re-use the existing stuff (there was no extcon-usb-gpio at
> > the time of writing my driver), then had to return to the separate driver
> > idea...
> >
> > > "So
> > > what" and "I'd like to keep my spacing as is" aren't valid reasons.
> > > Fix it, then I'll look at the rest again.
> >
> >     I'll consider doing that if you care to explain what's the problem with
> > my spacing. TIA.
>
> You are mixing 2 and 1 spaces between words, don't do that.

   Care to just explain why?

MBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/