[PATCH 1/2] devicetree: mxsfb: add reset-active property

[Mans Rullgard]

Some boards connect the LCD_RESET pin to a reset input on the
display panel.  On these boards, this pin must be set to the
proper level for the display to function.

This adds an optional "reset-active" property to the "display"
subnode such that devicetrees can specify the desired polarity
of the LCD_RESET pin.

Signed-off-by: Mans Rullgard <mans@xxxxxxxxx>
---
 Documentation/devicetree/bindings/display/mxsfb.txt | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/display/mxsfb.txt b/Documentation/devicetree/bindings/display/mxsfb.txt
index 96ec517..cb7212a 100644
--- a/Documentation/devicetree/bindings/display/mxsfb.txt
+++ b/Documentation/devicetree/bindings/display/mxsfb.txt
@@ -13,6 +13,11 @@ Required properties:
 - bits-per-pixel : <16> for RGB565, <32> for RGB888/666.
 - bus-width : number of data lines.  Could be <8>, <16>, <18> or <24>.
 
+Optional properties:
+- reset-active : <0>: reset pin is active low
+                 <1>: reset pin is active high
+                 omitted: reset pin not used
+
 Required sub-node:
 - display-timings : Refer to binding doc display-timing.txt for details.
 
-- 
2.6.3

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/